A junior network engineer needs to configure a network interface with the IP address 10.1.1.1 and a subnet mask of 255.255.255.0.
Which of the following are valid ways to express this configuration on an HPE Aruba Networking CX switch? (Select all that apply.)

• A.`ip address 10.1.1.1/24`
• B.`set ip address 10.1.1.1 mask 255.255.255.0`
• C.`ipv4 address 10.1.1.1/24`
• D.`ip address 10.1.1.1/255.255.255.0`
• E.`ip address 10.1.1.1 255.255.255.0`

Comment: *

Name: *

Email: *

Verification: *

A network operator is troubleshooting an application that sends a large amount of data using UDP. Users are complaining that the data is arriving corrupted. The operator states that UDP itself cannot fix this.
Why is this statement correct?

• A.The UDP checksum is optional for IPv4 and does not provide guaranteed error correction.
• B.UDP uses the IP protocol's checksum, so it doesn't need its own.
• C.UDP relies on the Application Layer to implement any error checking.
• D.UDP's header is too small to contain a checksum field.

Comment: *

Name: *

Email: *

Verification: *

A Solutions Architect is designing a new, highly resilient access layer using a stack of HPE Aruba Networking CX 6300 switches. To simplify management and provide seamless redundancy, the architect has decided to use the Virtual Switching Framework (VSF) to stack two switches together.
* Switch 1 (Future Commander): The architect is connected to this switch via the console.
* Switch 2 (Future Standby): Is in a factory default state.
* VSF Links: The switches will be connected in a ring topology using the dedicated VSF ports 1 and 2 on the rear of the switches.
* VSF Domain ID: 10
Which of the following command sets, when executed on Switch 1, correctly initiates the VSF formation process?

• A.switch(config)# vsf member 1 priority 200
  switch(config)# vsf member 2 priority 100
  switch(config)# vsf enable domain 10
• B.switch(config)# vsf link 1 interface 1/1
  switch(config)# vsf link 2 interface 1/2
  switch(config)# vsf enable domain 10
• C.switch(config)# vsf enable domain 10
  switch(config)# vsf renumber-to 1
• D.switch(config)# vsf member 1 link 1 1/1/49
  switch(config)# vsf member 1 link 2 1/1/50
  switch(config)# vsf enable domain 10

Comment: *

Name: *

Email: *

Verification: *

A Security Analyst is hardening a network and wants to implement filtering rules that block specific types of traffic based on the logical addresses of the source and destination. For example, they want to block all traffic from the 10.0.0.0/8 network.
At which layer of the OSI model do routers and multi-layer switches make forwarding decisions based on this type of logical addressing? (Choose 2.)

• A.Layer 4 (Transport)
• B.This is a function of a firewall, not a specific OSI layer.
• C.Layer 3 (Network)
• D.Layer 7 (Application)
• E.Layer 2 (Data Link)

Comment: *

Name: *

Email: *

Verification: *

What is the primary purpose of implementing a LAG in a network environment?

• A.To reduce the overall cost of network infrastructure deployment
• B.To increase the number of network devices connected to the network
• C.To aggregate multiple physical links into a single link for increased bandwidth and redundancy
• D.To prioritize specific types of traffic over others

Comment: *

Name: *

Email: *

Verification: *