Free HP HPE7-A07 Exam Dumps Questions & Answers

A customer's infrastructure is set up to use both primary and secondary gateway clusters on the SSID profile cased on best practices. Why do they have an equal split of their 120 APs across the primary and secondary gateway clusters?

• A.  The secondary gateway cluster is a homogeneous cluster with six nodes.
• B.  The primary gateway cluster is a heterogeneous cluster with six nodes.
• C.  The primary and secondary gateway clusters are up. but the cluster preemption Is not enabled
• D.  The primary and secondary gateway clusters are up. and the cluster preemption is enabled

A customer's infrastructure is set up to use Doth primary and secondary gateway clusters on the SSID profile What is a valid reason for the AP to failover to the secondary gateway cluster?

• A.  The secondary gateway cluster is homogeneous.
• B.  The secondary gateway cluster is heterogeneous.
• C.  The secondary gateway cluster is up. hut the AP is unable to reach the secondary gateway cluster
• D.  The primary gateway cluster is up. out the AP is unable to reach the primary gateway cluster.

Exhibit.

What is me expected behavior for ARP traffic sent from H1?

• A.  A2 will drop the ARP traffic.
• B.  A2 will flood the ARP traffic out of all interfaces.
• C.  A2 will send the ARP traffic out of ports 1/1/1 and 1/1/3.
• D.  A2 will send the ARP traffic out of ports 1/1/1-1/1/4.

A customer has recently deployed AP-615s at their new office and is wondering on which band the radios will operate with the default configuration after creating a tri-band SSID. What should you tell them?

• A.  The AP will operate on the 2.4GHz and 5GHz bands
• B.  The AP will operate on the 2.4GHz and 6GHz bands
• C.  6GHz will not be used unless manually configured
• D.  The AP will operate on the 5GHz and 6GHz bands

A customer is evaluating device profiles on a CX 6300 switch. The test device has the following attribute:

* MAC address=81:cd:93:13:ab:31
The test device needs to be assigned the "lot-prod'' role, in addition the "lot-default" role must be applied for any other device connected lo interface 1/1/1. This is a lab environment with no configuration of any external authentication server for the test.
Given the configuration example, what is required to meet this testing requirement?

• A.  Enter the command "port-access onboarding-method precedence" to set device profiles with a lower precedence.
• B.  Enter the command "port-access fallback-role lot-default globally
• C.  Enter the command "port-access device-profile mode block-until-profile-applied" globally.
• D.  Enter the command "pot-access device-profile mode block-until-profile-applied"" for interface 1/1/1.