Exhibit.

An engineer has applied the above configuration to R1 and R2 However the routers OSPF adjacency never progresses past the "EXSTART-DR" slate as shown below.

Which configuration action on either router will allow R1 and R2 to progress past the "EXSTART/DR" state?

• A.Change R1 and R2 to a network type of point-to-point.
• B.Remove the layer 3 MTU configuration.
• C.Ensure the OSPF process is not configured with passive-interface default.
• D.Change the IP address and mask applied to interface 1/1/1.

Comment: *

Name: *

Email: *

Verification: *

You configured a tunneled SSID with captive portal and a ClearPass Guest Self Registration workflow when testing and launching the self-registration workflow, after successful registration, the login action shows the following error:

What is the best solution to resolve this error?

• A.You need to include the root and intermediate certificates in the captive portal certificate for your access points
• B.You need to De connected to the guest SSiD while testing.
• C.You need to change the Login Address in ClearPass to securelogin arubanetworKs.com
• D.You need to include the root and intermediate certificates in the captive portal certificate for your gateway

Comment: *

Name: *

Email: *

Verification: *

After onboarding three new AOS 10 gateways using the full-setup methodinto the same Central group, a customer cannot log in to one of the gateways using the HPE Aruba Networking Central remote console due to an incorrect password.

• A.The admin password created using full-setup does not match the global Central admin password.
• B.The admin password created during the run-setup process is not configured to allow me remote console access
• C.The admin password created during the full-setup process does not match the Central group admin password
• D.The admin password created at the Central group level has expired

Comment: *

Name: *

Email: *

Verification: *