Free HP HPE7-A08 Exam Dumps Questions & Answers

How does an HPE Aruba Networking CX VSX solution make the hardware replacement of a single switch a non-disruptive operation for Layer 2 configurations?

• A.  By the VSX-sync option for synchronization of the system-MAC.
• B.  By entering the primary switch system-MAC on the secondary switch.
• C.  By the utilization of any of the four reserved ranges as system-MAC addresses.
• D.  By allowing the system MAC in the ServiceOS to be changed to the original system MAC.

Refer to the exhibit for an HPE Aruba Networking CX 6300M VSF:

If Member ID 1 fails, what would be the state of Member ID 2?

• A.  Standby
• B.  Conductor
• C.  Member
• D.  Not present

TAC has made a configuration change on the CLI of a CX switch using aruba-central support-mode. Which statement about the switch configuration in HPE Aruba Networking Central is true?

• A.  The user must make the same change in HPE Aruba Networking Central for synchronization to occur.
• B.  Config auto-commit will be disabled and must be re-enabled manually.
• C.  HPE Aruba Networking Central will automatically overwrite the configuration change.
• D.  The configuration change will be automatically synchronized to HPE Aruba Networking Central.

After configuring BFD for OSPF you are receiving monitoring alerts for high CPU utilization on your switches. Based on the configuration below, how should you resolve the issue?
Bash
bfd
!
router ospf 1
bfd all-interfaces

• A.  Disable ICMP redirects.
• B.  Ensure BFD is enabled on all passive OSPF interfaces.
• C.  Enable BFD echo mode.
• D.  Enable ICMP active mode.

While troubleshooting a scenario in which the customer has added two new line cards on an HPE Aruba Networking CX 6400 switch, the LEDs on the line card do not show light on the first card.
Which troubleshooting methodology should you use to isolate the problem?

• A.  Follow the path and check the connectivity from the access switch to the CX 6400.
• B.  Divide and conquer by swapping the line cards in their slot.
• C.  Replace the configuration using the previous checkpoint on the switch.
• D.  Spot the difference by comparing the switch configurations.