You are remotely connected to an HPE Aruba Networking CX 6200F switch using SSH to change the Control Plane ACL, allowing only defined subnets to access the switch. Which AOS-CX command allows you to roll back your change if the ACL change is wrongly formed and you can no longer log in to the switch?

• A.Use the checkpoint commit command after you commit the change.
• B.Use the checkpoint auto command before you commit the change.
• C.Use the checkpoint auto command after you commit the change.
• D.Use the checkpoint commit command before you commit the change.

Comment: *

Name: *

Email: *

Verification: *

Which Aruba CX switch series supports deep packet inspection for network security?

• A.Aruba CX 10000
• B.Aruba CX 6300
• C.Aruba CX 6200
• D.Aruba CX 4100i

Comment: *

Name: *

Email: *

Verification: *

Which CLI command checks queue utilization and dropped packets on an Aruba CX switch?

• A.show qos queue statistics
• B.display qos usage
• C.show queue counters
• D.show traffic priority

Comment: *

Name: *

Email: *

Verification: *

A customer with a gateway connected to a device on gigabitethernet 0/0/3 configures an Asset ID TLV on the device for inventory management.
Refer to the exhibit.

The customer mentions the Asset ID is not shown. What is causing the issue?

• A.LLDP-MED needs to be enabled.
• B.MTU size is too small.
• C.LLDP TX is not enabled.
• D.Unknown TLVs cannot be displayed.

Comment: *

Name: *

Email: *

Verification: *

What command is used to check VLAN assignments on an Aruba switch?
Response:

• A.show spanning-tree
• B.show vlan
• C.show interface status
• D.show mac-address-table

Comment: *

Name: *

Email: *

Verification: *