Free Huawei H11-811 Exam Dumps Questions & Answers

Assume that the prefix Oil has been configured on the U1960. For details, see the following figure. Which of the following statements are CORRECT? (Multiple Choice)

• A.  User A with advanced rights can dial numbers starting with Oil. Then, calls are routed through office route selection code 10.
• B.  User A with the international toll call rights can dial numbers starting with Oil. Then, calls are routed through office route selection code 10.
• C.  User A with common rights can dial numbers starting with Oil. Then, calls are routed through office route selection code 10.
• D.  User A with default rights can dial numbers starting with Oil. Then, calls are routed through office route selection code 10.

For U1900, which of the following steps must be involved for configuring a PRA trunk?
(Multiple Choice)

• A.  Configure the trunk board.
• B.  Configure rerouting upon a call failure.
• C.  Configure the office route number.
• D.  Configure the position where the PRA link is located.

Analog phone A registers with a U1960 unified gateway through the IAD proxy. IP phone B also registers with the U1960. If the U1960 encounters an unexpected power failure when A and B are engaged in a call, the call between A and B is interrupted immediately.

• A.  FALSE
• B.  TRUE

Which of the following statements is CORRECT about call rights and user rights on U1900?

• A.  The international call right can be used only for configuring the outgoing prefix.
• B.  User rights are configured during prefix configuration.
• C.  The international call right can be used for configuring prefixes only starting with 900.
• D.  If you do not configure the user right when a user is being added, the user right is Normal by default.

Requirement 2; If the calling number 7000 makes an outgoing call through the SIP trunk, the calling number needs to be changed to 28887000.
To implement the preceding requirements, which of the following configurations are CORRECT? (Multiple Choice)

• A.  On the Trunk tab page of the web configuration page, set Calling number change to Yes under Trunk Configuration > Advanced and the number change rule under Office Route Configuration > Number Change Index to implement requirement 1.
• B.  On the Trunk tab page of the web configuration page, set the number change rule under Office Route Configuration > Number Change Index to implement requirement 1.
• C.  On the Trunk tab page of the web configuration page, set the number change rule under Office Route Configuration > Number Change Index to implement requirements 1 and 2 at the same time.
• D.  On the Trunk tab page of the web configuration page, set the number change rule under Office Route Configuration > Number Change Index, as well as set the long number of the intra-office number 7000 to 28887000 and Display long calling number to Yes for the outgoing call prefix under User > SIP User to implement requirement 2.
• E.  On the Trunk tab page of the web configuration page, set Calling number change to Yes under Trunk Configuration > Advanced and the number change rule under Office Route Configuration > Number Change Index to implement requirements 1 and 2 at the same time.