Which of the following statements are true about RIPng? (Multiple Choice)

• A.RIPng supports MD5 authentication
• B.Each RIPng update packet contains a maximum of 25 routes
• C.RIPng supports a maximum of 32 hops
• D.RIPng uses the link local address to send update packets
• E.RIPng does not have an authentication mechanism

Comment: *

Name: *

Email: *

Verification: *

The interface of an existing router Serial0 OSPF 1 Serial0 Silent is going to go and set the interface as an interface. Then what will happen?
Impact?

• A.OSPF does not add routes learned from the interface to the local routing table.
• B.OSPF does not pass the interface to establish any connection.
• C.The OSPF interface establishes the available connections.
• D.OSPF will receive routing updates from neighbors.

Comment: *

Name: *

Email: *

Verification: *

OSPFv3 OSPFv2 OSPFv3 protocol Single-issue protocol is a separate one. It differs from the other in terms of road-based rather than network segment chain.
The next thing is to say the mistake ?

• A.Pairing the two routers connected to the road, even if you do not configure the broadcast IPv6 address, you can establish a neighbor.
• B.In addition to the virtual connection, all interfaces use the address of the address composition OSPFv3 Link-local
• C.Two routers connected to the link, even if their IPv6 addresses are differently suffixed, they can still establish a neighbor relationship.
• D.The OSPFv3 Link-local router obtains the next hop of the neighboring address from the neighboring routing information.

Comment: *

Name: *

Email: *

Verification: *

Which tool can be used to select BGP route based on the path that the route has followed?

• A.AS-path-filter
• B.IP-prefix
• C.Community-filter
• D.ACL

Comment: *

Name: *

Email: *

Verification: *

The following about the attribute BGP RD ( ) filter, is the description correct? Multiple selection

• A.If there is no configuration, but reference RD-filter RD-filter deny, this is the filter line, the match is the result
• B.The use of the RD-filter " configuration is the relationship between rules or
• C.If configured, but the route does not match any of the specified RD-filter RD RD Permit rules, the default match is then recognized.
• D.Multiple, according to the configuration, the line matching rules

Comment: *

Name: *

Email: *

Verification: *