As shown in the figure, 1 2 , , URPP routers share the traffic between the branch network load network and the branch network. In this case, configure the router physical interface.
Source address bullying must use loose mode P to spoof.

• A.False
• B.True

Comment: *

Name: *

Email: *

Verification: *

which of the following statements is true according to the topology shown?

• A.Because route summarization is configured on R2, only the routing entry 10.0.0./16 exist in the IP routing table of R1.
• B.Routing entries 10.0.2.2/32 and 10.0.0.0/16 exist in te IP routing table of R1.
• C.Routing entries 10.0.3.3/32 and 10..0.0./16 exist in the IP routing table of R1.
• D.Routing entries 10.0.2.2/32 and 10.0.3.3/32 exist in the IP routing table of R1.

Comment: *

Name: *

Email: *

Verification: *

Which of the following can be used for BGP route selection? (Multiple Choice)

• A.AS-PATH-FILTER
• B.IP-PREFIX
• C.ACL
• D.DSCP

Comment: *

Name: *

Email: *

Verification: *

Which type of pre-announcement advertises its own BGP IBGP (the prefix to the neighboring fake router is not configured with a route reflector)?

• A.Presences existing in routing shows
• B.The former is the EBGP RR neighbors, or the previous ones
• C.Previously passed other IBGP EBGP neighbors, or formerly learned from the neighboring habits, or the previous introduction of the routing
• D.Previously passed other BGF network neighbors, or previously localized or routed to learn
• E.Before being acquainted with EBGP network, or before being localized or routed.

Comment: *

Name: *

Email: *

Verification: *

Router A has an IP route with the destination network segment of 10.0.0.1/32 and outbound interface of GigabitEthernet0/0/1. The following configuration is added:

Assume that router A receives a data packet with the destination IP address of 10.0.0.1.
Which of the following statements are true?

• A.If the source IP address of the data packet is 10.0.1.2, the data packet cannot be forwarded.
• B.If the source IP address of the data packet is 10.0.1.2, the data packet can be forwarded and the DSCP value is set to CS3.
• C.If the source IP address of the data packet is 10.0.1.1, the data packet can be forwarded and the DSCP value is set to CS3
• D.If the source IP address of the data packet is 10.0.1.2, the data packet can be forwarded and the DSCP value remains unchanged.

Comment: *

Name: *

Email: *

Verification: *