What parameters can the DHCPv6 server assign to the DHCPv6 client? (Multiple choice)

• A.SNTP server address
• B.DNS server address
• C.IPv6 address prefix
• D.Gateway address

Comment: *

Name: *

Email: *

Verification: *

The following procedure for NDP to resolve the link layer address is correct or not.

• A.False
• B.Ture

Comment: *

Name: *

Email: *

Verification: *

RTA is the source DR router and RTB is the RP router. The multicast source sends multicast data to RTA, but the multicast source Source registered to it through the PIM Register message cannot be seen on RTB. What are the possible reasons? (Multiple questions)

• A.The multicast network dynamically elects the RP, but the RTA's RPF check on the BSR fails
• B.The RP elected by RTA is not RTB
• C.The multicast network is statically configured with RP, but the RTA router is not statically configured with RP
• D.There is no unicast route from RTB to RTA, causing RTB to fail to check the source RPF

Comment: *

Name: *

Email: *

Verification: *

The interface Serial0 of an existing router is in OSPF area 1, and the interface Serial0 is set to the Silent interface, so what effect does this setting have?

• A.OSPF does not add routes learned from the interface to the local routing table.
• B.OSPF does not establish any adjacencies through the interface.
• C.OSPF will receive routing updates from neighbors
• D.OSPF establishes available adjacencies through this interface.

Comment: *

Name: *

Email: *

Verification: *

What is the relationship between CIR, BC and TC?

• A.CIR=BE/TC
• B.TC=CIR/BC
• C.TC=BC/CIR
• D.CIR=TC/BC

Comment: *

Name: *

Email: *

Verification: *