According to the following configuration example, the following statement is correct ().
[AC] dhcp enable
[AC] interface VLANif100
[AC-VLANif100] ip address 10.1.100.1 24
[AC-VLANif100] dhcp select interface
[AC-VLANif100] quit

• A.The dhcp select interface command is to enable the DHCP client function on the VLAN 100 interface
• B.The DHCP service is already enabled by default in the global mode, so dhcp enable does not need to be configured
• C.If VLAN100 is a user VLAN, after the user receives the address, the gateway is 10.1.100.1 and the mask is 255.255.255.0
• D.If VLAN100 is the management VLAN where the AP is located, the option 43 field in the DHCP message that the AP will receive should be 10.1.100.1

Comment: *

Name: *

Email: *

Verification: *

Which of the following are the relevant parameters of the Traffic template ().
(Select 2 Answers)

• A.Tunnel priority mapping strategy
• B.CAC strategy
• C.802.3 priority mapping strategy
• D.ACK strategy

Comment: *

Name: *

Email: *

Verification: *

WEP The encrypted data algorithm uses () algorithm.

• A.CCMP
• B.AES
• C.Asymmetric encryption
• D.RC4

Comment: *

Name: *

Email: *

Verification: *

If there is a high demand for WLAN capacity in a coverage area, the construction method of () should be considered.

• A.Combination of indoor distribution system
• B.Outdoor AP+ directional antenna
• C.Combination of outdoor distribution system
• D.Indoor installation

Comment: *

Name: *

Email: *

Verification: *

A 10 Floors of buildings need to be covered WLAN Signal, because taking into account the floor block, which can be set to 6 channel.
5,6 Layered WLAN Signal frequency

• A.False
• B.True

Comment: *

Name: *

Email: *

Verification: *