As shown in the figure, the correct description of this network topology is ().
Which of the following descriptions about wireless devices is correct?
The output information of the sub-interface of a router aggregate port 1 is shown in the figure. Based on this information, which of the following statements are correct? (Multiple Choice)
[Router A]display Interface Eth-Trunk 1.100
Eth-Trunk1.100 current state : UP
Line protocol current state : UP
Last line protocol up time : 2019-03-04 10:22:40 UTC -08 :00
Description: HUAWEI, AR Series, Eth-Trunk1.100 Interface
Route Port, Hash arithmetic : According to SIP-XOR-DIP, Maximal BW: 2G, Current BW: 2G, The Maximum Transmit Unit is 1500
Internet Address is 10.0.12.2/24
IP Sending Frames' Format is PKTFIT ETENT 2.Hardware address 1s 00e0-fc3b-2015
Current system time: 2019-03-04 10:24:29 -08:00
Last 300 seconds input rate 0 bits/sec, 0 packets/sec
Last 300 seconds output rate 0 bits/sec, 0 packets/sec
Realtime 0 seconds input rate 0 bits/sec, 0 packets/sec
Realtime 0 seconds output rate 0 bits/sec, 0 packets/sec
Input: 6 packets, 574 bytes,
Output:7 packets, 638 bytes,
Input bandwidth utilization ;0%
Output bandwidth utilization :0%
--------------------------------
PortName Status Weight
--------------------------------
GigabitEthernet0/0/1 UP 1
GigabitEthernet0/0/2 UP 1
--------------------------------
The Number of Ports in Trunk : 2
The Number of UP Ports in Trunk : 2
What command views exist in the VRP operating platform? (Multiple choice)
In the network shown in the figure below, assuming that all routers enable the OSPF protocol at the same time, which router is the BDR in this network?
Enter your email address to download Huawei.H12-811-ENU.v2022-07-12.q110 Dumps