The administrator hopes that all hosts cannot access the Internet from 8:00-17:00 every day, so in the interface configuration of GO/0/1, trahic-HIter outbounD. Which ACL rule needs to be bound? ()

• A.time-range am9topm5 08:00 to 17:00 daily acl number 2001 rule 5 deny time-range am9topm5
• B.time-range am9topm5 08:00 to working-day Acl number 2003 rule 5 deny time-range am9topjni5
• C.time-range am9topm5 07:00 to 18:00 daily Acl number 2002
• D.time-range am9topm5 08:00 to 17:00 off-day acl number 2004 rule 5 permit timerange

Comment: *

Name: *

Email: *

Verification: *

Router A.
and Router B are established OSPF neighbor relationship, the OSPF process number of router A.
is 1, and the area number is 0. Which of the following configurations on router A can enable router B to obtain the route of the network segment where host A is located? ()

• A.ospf 1 AreA.0.0.0.0 Network 192.168.1.00.0.0.255
• B.ospf 1 Import-route direct
• C.ospf 1 AreA.0.0.0.0 Network 192.168.0.00.0.255.255
• D.ospf 1 AreA.0.0.0.0 Network 192.168.1.2 0.0.0.0

Comment: *

Name: *

Email: *

Verification: *

The output information of a router's routing table is shown in the figure. Which of the following statements is correct? () (Multiple Choice Questions)

• A.The outbound interface of this router to 10.0.2.2 is Ethernet0/0/1
• B.The outgoing interface of this router to 10.0.2.2 is Ethernet0/0/0
• C.The outgoing interface of this router to 10.0.0.1 is Ethernet0/0/0
• D.The outbound interface of this router to 10.0.0.1 is Ethernet0/0/1

Comment: *

Name: *

Email: *

Verification: *

The output information of the sub-interface of a certain router's aggregation port 1 is shown in the figure. Based on this information, which of the following statements is correct? ( )
[Router A] display Interface Eth-Trunk 1.100Eth-Trunk1.100 current state UP Line protocol current state UP Last line protocol up time 2019-03-04 10:22:40 UTC.-08:00 Description: HUAWEI, ARSeries, Eth-Trunk1.100 Interface Route Port, Hash arithmetiC.:According to SIP-XOR-DIP, Maximal BW:2G.Current BW:2G, The Maximum Transmit Unit is 1500 Internet Address is 10.0.12.2/24 IP Sending Frames'Format is PKTFIT ETENT 2, Hardwareaddress 1s 00e0-fc3b-2015 Current system time:2019-03-04 10:24:29-08:00 Last 300 seconds input rate0 bits/sec.0 packets/sec Last 300 seconds output rate 0 bits /seC.0 packets/sec Realtime 0 seconds inputrate 0 bits/seC.0 packets/sec Realtime 0 seconds output rate 0 bits/seC.0 packets/sec Input: 6 packets, 574 bytes, Output: 7 packets, 638 bytes, Input bandwidth utilization 0% Output bandwidth utilization 0% PortName Status Weight GigabitEthernet0/0/1 UP 1 GigabitEthernet0/0/2 UP 1 The Number of Ports in Trunk:2 The Number of UP Ports in Trunk:2*

• A.The sub-interface number of the aggregate port is 100
• B.The sub-interface of the aggregate port carries VLAN TAG100 when forwarding data frames
• C.The P address of the sub-interface of the aggregate port is 10.0.12.2/24
• D.Two links exist on the aggregated port

Comment: *

Name: *

Email: *

Verification: *

The wireless access controller (AC, Access Controller) is the overall management and control device in the FIT AP architecture. What is wrong about the role of AC in the following description?

• A.User access authentication
• B.Regardless of the data forwarding method, the user's data packets are forwarded by the AC
• C.AP configuration delivery
• D.User access control

Comment: *

Name: *

Email: *

Verification: *