The VRRP is enabled on the firewall dual-system Intranet users use NAT to access extranet FTP services Which of the following statements are true?
The Huawei router is the last hop DR where the SSM Mapping function is enabled at the interface.
Some IGMPv2 hosts expect to receive (1.0.0.1, 232.1.0.1), (1.0.0.1, 232.1.0.2), and (2.0.0.1,
232.1.3.2) dat
a. How can you satisfy the preceding requirements with the least configurations?
Refer to the exhibit
As shown in the figure, basic BGP/MPLS IP VPN configuration has been completed on routers. Which of the following configurations is incorrect for advertising default routes in VPN instances on the SPE?
Note: All configurations are performed on the SPE.
All nodes in the topology belong to the same IGP are
a. They can learn routers from each other and have the TE capability. The tunnels configured below can be Up. Refer to the following configuration of RTA,Which of the following statements are true?
#
mpls lsr-id 1.1.1.1
mpls
mpls te
mpls rsvp-te
mpls te cspf
#
explicit-path pri-path
next hop 3.1.1.2
next hop 4.1.1.2
next hop 5.1.1.2
#
explicit-path bypass-1
next hop 2.1.1.2next hop 6.1.1.1
#
explicit-path bypass-2
next hop 2.1.1.2
next hop 7.1.1.2
#
explicit-path bypass-3
next hop 8.1.1.2
next hop 9.1.1.2
#
interface Tunnel1/0/0
ip address unnumbered interface LoopBack0
tunnel-protocol mpls te
destination 4.4.4.4
mpls te tunnel-id 100
mpls te record-route label
mpls te path explicit-path pri-path
mpls te fast-reroute
mpls te commit
#
interface Tunnel2/0/0
ip address unnumbered interface LoopBack0
tunnel-protocol mpls te
destination 2.2.2.2
mpls te tunnel-id 101
mpls te record-route label
mpls te path explicit-path bypass-1
mpls te bypass-tunnel
mpls te protected-interface GigabitEthernet 3/0/0
mpls te commit
#
interface Tunnel2/0/1
ip address unnumbered interface LoopBack0
tunnel-protocol mpls te
destination 3.3.3.3
mpls te tunnel-id 102
mpls te record-route label
mpls te path explicit-path bypass-2
mpls te bypass-tunnel
mpls te protected-interface GigabitEthernet 3/0/0
mpls te commit
#
interface Tunnel2/0/2ip address unnumbered interface LoopBack0
tunnel-protocol mpls te
destination 4.4.4.4
mpls te tunnel-id 103
mpls te record-route label
mpls te path explicit-path bypass-3
mpls te bypass-tunnel
mpls te protected-interface GigabitEthernet 3/0/0
mpls te commit
#
Exhibit.
The figure shows the typically mode in which a commonsoftswitchaccess the bearer network. VRRP is
enabled on RTA and RTB. In normal cases, RTA is the VRRP master router and RTB is the VRRP is the
VRRP salve router. The ETH_trunk is enabled between RTA RTB. IF VRRP is not bounded to BFD and each
[parameter uses their default settings, which statement is the true when the upstream link of RTA is faulty?
