Free Huawei H31-341-ENU Exam Dumps Questions & Answers

Which of the following description of the PM_BIP8 related alarm is correct?

• A.  The PM_BIP8_SD alarm indicates the PM segment signal degradation alarm in the OTU layer.
• B.  The PM_BIP8_DEG alarm indicates the PM segment signal degradation alarm in the ODU layer.
• C.  The PM_BIP8_OVER alarm indicates that PM error amount has exceeded in the ODU layer.

What are the prerequisites for creating a bidirectional MPLS tunnel? (Multiple Choice)

• A.  The LSR ID of each NE is correctly configured.
• B.  Port properties have been configured correctly
• C.  Determine the bandwidth of the MPLS Tunnel
• D.  Users have network administrator user rights of "Administrators" and above

Which of the following are limitations of the alarm and performance analysis methods? (Multiple Choice)

• A.  When some faults occur, there may be no obvious alarms or performance events reported, and sometimes no alarms or performance events are found.
• B.  In the case of complex networking, service, and fault information, many alarms and performance events may occur along with the occurrence of faults. Due to too many reports and performance events, maintenance personnel are unable to analyze.
• C.  The network administrator cannot obtain the current notifications of the device, the alarm occurrence time, and the historical alarm of the device.
• D.  Field maintenance personnel cannot understand the current operating condition of the equipment.

Which of the following reasons does not cause optical power anomalies?

• A.  Pigtail connection error
• B.  The pigtail is too large
• C.  Equipment temperature is too high
• D.  Enable FEC function

TEM28 is the Ethernet convergence tributary board. Which of the following descriptions about the TEM28 board are correct? (Multiple Choice)

• A.  The electrical signal can be output ODU0, ODU1flex, 00U1 or ODU2 signals to the backplane for cross scheduling through operations such as encapsulation mapping and OTN framing.
• B.  The TEM28 board supports the L2 switch module and needs to configure the port to VCTRUNK service.
• C.  TEM28 can simultaneously access FE, GE, 10GE LAN and 10GE WAN services through different ports.
• D.  RX1/TX1~RX4/TX4 ports are 10GE optical ports, which can handle 10GE LAN/10GE WAN services. Other interfaces are GE optical ports, GE electrical interfaces or FE electrical ports which can handle GE or FE services.