Free IBM C4040-121 Exam Dumps Questions & Answers

What is the tool used to aid in upgrade planning for interdependencies of HMC and system firmware upgrades?

• A.  System Planning Tool
• B.  Pre-Upgrade Verification Tool
• C.  Firmware Validation Tool
• D.  IBM Fix Level Recommendation Tool

An IBM i client partition is experiencing a network issue and has collected performance data. What Performance Tools command/commands could be used to show the network I/O throughput and percentage of packet errors?

• A.  PRTSYSPPT MBR(Qxxxxxxx) TYPE(*TCPIP) PRTCPTRPT MBR(Qxxxxxxx) TYPE(*TCPIP)
• B.  PRTSYSPPT MBR(Qxxxxxxx) TYPE(*CMN) PRTCPTRPT MBR(Qxxxxxxx) TYPE(*IOP)
• C.  PRTJOBRPT MBR(Qxxxxxxx) SLTLINE(*ALL) PRTRSCRPT MBR(Qxxxxxxx) TYPE(*IOP)
• D.  PRTPOLRPT MBR(Qxxxxxxx) SLTLINE(*ALL)

After installing a client AIX partition, supported by a hosting IBM i 7.1 partition, each subsequent IPL of the AIX partition boots to "System Management Services" mode.
Where should the change to boot the AIX environment to "Normal" mode be made?

• A.  In the hosting IBM i partition profile --> Settings --> Boot Mode
• B.  In the client AIX partition profile --> Settings --> Boot Mode
• C.  In the "Properties" section of the AIX partition --> Keylock Position
• D.  In the client AIX partition --> bosboot --> bosboot -n -f

A client IBM i partition running 6.1 is being upgraded to 7.1 using an image catalog on an IBM i 6.1 partition. The image catalog is loaded into a virtual optical device and made available to the client partition using a Network Server Description and virtual SCSI adapters.
Which statement is correct?

• A.  The virtual optical device performs as a library in IBM i 6.1.
• B.  The next volumes will have to be mounted manually, one by one.
• C.  The device will show on the client with the same name as on the host.
• D.  The virtual optical device should be specified in the NWSD before it can be seen by the client partition.

While creating a new partition and choosing appropriate I/O resources, nothing appears on the Tagged I/O screen to be selected as a "Load Source." Which of the following could cause this to happen?

• A.  Supported resources for a load source adapter have not been included in the profile.
• B.  The CEO is not in "standby' mode.
• C.  Resources are only marked as Desired, not as Required.
• D.  The disk attached to the controller is not powered-on.