Which two statements are correct about the inet.0 routing table? (choose two.)

• A.It stores information learned from routing protocols and other sources.
• B.It is used for populating the forwarding policy.
• C.It is used for populating the Ethernet switching table.
• D.It is used for populating the forwarding table.

Comment: *

Name: *

Email: *

Verification: *

Which of these commands shows ONLY interfaces that are administratively and operationally up?

• A.show interfaces terse | match down
• B.show interfaces terse | except down
• C.show interfaces terse | except up
• D.show interfaces terse | match up

Comment: *

Name: *

Email: *

Verification: *

Which of these are true about the primary address of an interface? (Choose two)

• A.It can be useful for selecting the local address used for packets sent out of unnumbered interfaces when multiple non-127 addresses are configured on the loopback interface.
• B.By default, the primary address on an interface is selected as the numerically highest local address configured on the interface.
• C.It is the address used by default as the local address for broadcast and multicast packets sourced locally and sent out of the interface
• D.The primary address is used when you have multiple IP addresses belonging to the same subnet on the same interface.

Comment: *

Name: *

Email: *

Verification: *

What is the interface name for the third SONET interface on a PIC installed in PIC slot 1, FPC slot 1?

• A.interface so-3/1/1
• B.interface so-1/1/2
• C.interface sonet-1/1/3
• D.interface so-0/1/1.2

Comment: *

Name: *

Email: *

Verification: *

Which two statements describe the connection baetween the control plane and the forwarding plane? (Choose two.)

• A.A rate limiter is configured by default.
• B.Control traffic is preferred over exception traffic during congestion.
• C.Exception traffic is preferred over control traffic during congestion.
• D.No rate limiter is configured by default.

Comment: *

Name: *

Email: *

Verification: *