Free Juniper JN0-1301 Exam Dumps Questions & Answers

You are creating a design proposal and deciding whether to use 10 GbE copper or 10GbE fiber cabling to connect your ToR switches to the servers.
Which statement is correct regarding this scenario?

• A.  Copper cabling requires special transceivers for different speeds.
• B.  Fiber is much cheaper to purchase but has a higher long-term cost.
• C.  Copper will allow you to reach the greatest distance between devices.
• D.  Fiber has a lower power consumption on a per-port basis.

You plan to deploy a set of SRX Series devices in an active/passive chassis cluster with an active/passive network infrastructure. Which two statements are true in this scenario?
(Choose two.)

• A.  In non-failure conditions, the end-host traffic across the fabric link is present.
• B.  In non-failure conditions, the end-host traffic across the fabric link is eliminated.
• C.  End-host traffic is serviced through one SRX node during non-failure conditions.
• D.  End-host traffic is serviced through both SRX nodes during non-failure conditions.

You are designing a Junos-based Ethernet Fabric for a data center that has a combination of 60 EX Series and QFX Series devices.
In this scenario, which solution would you choose?

• A.  Virtual Chassis Fabric
• B.  Junos Fusion Data Center
• C.  Junos Fusion Provider Edge
• D.  Virtual Chassis

A customer is using EVPN to maximize their Data Center Interconnect and provide a stretched Layer 2 network to support VM mobility. What are two benefits in this scenario? (Choose two.)

• A.  Load balancing is used across the WAN per flow
• B.  Load balancing is used across the WAN per packet
• C.  Layer 2 MAC tables are populated using the data plane
• D.  Layer 2 MAC tables are populated using the control plane

Your data center uses an Ethernet fabric solution for the infrastructure switches.
You must design a redundancy solution that addresses how the servers connect to the members of the Ethernet fabric. Which two statements are true in this scenario? (Choose two.)

• A.  You should connect each server to two different members.
• B.  It is necessary to use MC-LAG.
• C.  It is not necessary to use MC-LAG.
• D.  You should connect each server to one member with a two-interface LAG.