Free Juniper JN0-333 Exam Dumps Questions & Answers

Click the Exhibit button.

Which two statements describe the output shown in the exhibit? (Choose two.)

• A.  Redundancy group 1 experienced an operational failure.
• B.  Node 0 is controlling traffic for redundancy group 1.
• C.  Redundancy group 1 was administratively failed over.
• D.  Node 1 is controlling traffic for redundancy group 1.

Which statement is true about functional zones?

• A.  Functional zones provide a means of distinguishing groups of hosts and their resources from one another.
• B.  Functional zones are a collection of regulated transit network segments.
• C.  Functional zones are the building blocks for security policies.
• D.  Functional zones are used for management.

You must verify if destination NAT is actively being used by users connecting to an internal server from the Internet.
Which action will accomplish this task on an SRX Series device?

• A.  Examine the active security flow sessions.
• B.  Examine the NAT translation table.
• C.  Examine the destination NAT translations table.
• D.  Examine the installed routes in the packet forwarding engine.

You recently configured an IPsec VPN between two SRX Series devices. You notice that the Phase1 negotiation succeeds and the Phase 2 negotiation fails.
Which two configuration parameters should you verify are correct? (Choose two.)

• A.  Verify that the IPsec policy references the correct IKE proposals.
• B.  Verify that the IKE gateway proposals on the initiator and responder are the same.
• C.  Verify that the VPN tunnel configuration references the correct IKE gateway.
• D.  Verify that the IKE initiator is configured for main mode.

Click the Exhibit button.

A customer would like to monitor their VPN using dead peer detection.
Referring to the exhibit, for how many minutes was the peer down before the customer was notified?

• A.  5
• B.  4
• C.  3
• D.  2