Free Juniper JN0-346 Exam Dumps Questions & Answers

Host-1 was recently added in the network and is attached to ge-0/0/10 on Switch-A. Host-1 is powered on
and has its interface configured with default Layer 2 settings and an IP address on the 172.17.12.0/24 IP
subnet. Host-1's MAC address is not shown in Switch-A's bridging table. What are three explanations for
this state? (Choose three.)

• A.  The ge-0/0/10 interface is configured as an access port.
• B.  The ge-0/0/10 interface is not operationally or administratively up.
• C.  The ge-0/0/10 interface has not received any traffic from Host-1.
• D.  The ge-0/0/10 interface is configured as a trunk port.
• E.  The ge-0/0/10 interface does not have an associated IRB.

Which two statements are correct regarding the root bridge election process when using STP? (Choose
two.)

• A.  A higher system MAC address is preferred.
• B.  A higher bridge priority is preferred.
• C.  A lower bridge priority is preferred.
• D.  A lower system MAC address is preferred.

Which three statements are correct about the voice VLAN feature? (Choose three.)

• A.  It allows trunk ports to accept tagged voice and untagged data packets.
• B.  It must use the same VLAN ID as data traffic on a defined interface.
• C.  It allows the access port to accept tagged voice and untagged data packets.
• D.  It allows you to apply independent CoS actions to data and voice packets.
• E.  It can be used with LLDP-MED to dynamically assign the VLAN ID value to IP phones.

Click the Exhibit button. Referring to the exhibit, Router-1 and Router-2 are failing to form an IS-IS
adjacency. What should you do to solve the problem?

• A.  Remove the overloaded statement from Router-1.
• B.  Change the IP subnet masks to match on the ge-0/0/2 interfaces of both routers.
• C.  Change the ISO areas on the Io0 interfaces to match on both routers.
• D.  Remove the ISOaddress fromge-0/0/2 on Router-1

Click the Exhibit button. Referring to the exhibit, what is the problem?

• A.  LACP is required for LAG to work.
• B.  The LAG member interfaces are configured across different line cards.
• C.  Aggregated interfaces must be defined under the chassis stanza.
• D.  LAG requires more than two member links.