Free Juniper JN0-361 Exam Dumps Questions & Answers

Click the Exhibit.

Referring to the configuration in the exhibit, which two statements are true? (Choose two.)

• A.  The next-hop 172.16.1.2 must be part of an active route in route table inet.0 for route 192.168.5.0/24 to be active.
• B.  The next-hop 172.16.1.2 must respond to ping commands for the route 192.168.5.0/24 to be active.
• C.  The next-hop 172.16.1.2 must be active in route table inet.3 for the route 192.168.5.0/24 to be active.
• D.  The next-hop 172.16.1.2 must be directly connected to the router for route 192.168.5.0/24 to be active

You want to save adjacency formation time between two routers participating in OSPF, as well as reduce the size of the OSPF link-state database.
How would you accomplish these tasks?

• A.  Configure a virtual link.
• B.  Specify a backup designated router.
• C.  Define a point-to-point connection.
• D.  Specify a designated router.

What must be configured for all IBGP speakers in an AS to have consistent routing information?

• A.  Static routes to the EBGP gateways
• B.  Partial mesh of EBGP sessions between EBGP speakers
• C.  Default routes to the IBGP gateways
• D.  Full mesh of IBGP sessions between IBGP speakers

You are using RSVP to signal an MPLS LSP.
Which statement is true in this scenario?

• A.  LSPs can be configured without any traffic engineering constraints.
• B.  The traffic engineering database must be used for all LSPs.
• C.  A primary path must be configured to establish an LSP.
• D.  A secondary path must be configured to establish an LSP.

Click the Exhibit.

Referring to the exhibit, R-1 and R-2 are connected with a LAG on the ae0 interface. However, the LAG is not operational.
Which action will solve this problem?

• A.  Set the LACP system priority to a non-zero value on one device.
• B.  Change the system ID on one device.
• C.  Change one device to use LACP passive mode.
• D.  Set the LACP system priority to a non-zero value on both devices.