You are asked to change the default TTL handling behavior on your Junos device to ensure that the RSVP-signaled LSPs in your MPLS network cannot be mapped.
Which configuration should be performed to accomplish this task?

• A.Configure the no-propagate-ttl parameter for each LSP on the egress device
• B.Configure the no-decrement-ttl parameter for each LSP on the egress device
• C.Configure the no-decrement-ttl parameter for each LSP on the ingress device
• D.Configure the no-propagate-ttl parameter for each LSP on the ingress device

Comment: *

Name: *

Email: *

Verification: *

Click the Exhibit button.

Referring to the exhibit, which statement is correct?

• A.Routes from 10.1.1.1 are less preferred than routes from 10.2.2.2
• B.Routes from 10.2.2.2 are less preferred than routes from 10.1.1.1
• C.Routes from 10.3.3.3 are less preferred than the default local preference
• D.Routes from 10.1.1.1 are less preferred than the default local preference

Comment: *

Name: *

Email: *

Verification: *

What Is a key differentiators of generate routes from aggregate routes?

• A.Generate routes have a default preference value of 210.
• B.Generate routes cannot be used as a gateway of last resort.
• C.Generate routes have a default next-hop value of reject.
• D.Generate routes use a forwarding next hop.

Comment: *

Name: *

Email: *

Verification: *

In your network, you have two LDP routers connected across four physical interfaces. You have also enabled LDP to operate on all four of those interfaces. What is the resulting outcome of your configuration between those two routers?

• A.Four sessions are built across one neighbor relationship
• B.Four sessions are built across four neighbor relationships
• C.One session is built across one neighbor relationship
• D.One session is built across four neighbor relationships

Comment: *

Name: *

Email: *

Verification: *

You are adding nonforwarding route reflectors to your network. Which three actions ensure that VPN routes are advertised properly? (Choose three.)

• A.Use rib-groups to add IGP routes to inet.3 and/or inet6.3 on the route reflectors.
• B.Use rib-groups to add VPN routes to inet.0 and/or inet6.0 on the route reflectors.
• C.Add the route reflectors to the same IGP domain as their clients.
• D.Add a static default route to inet.3 and/or inet6.3 on the route reflectors.
• E.Add MPLS LSPs between the route reflectors and their client routers.

Comment: *

Name: *

Email: *

Verification: *