You are deploying three WLAN 2.4 GHz networks in your US-based site. You must ensure that each network frequency is unique and does not overlap with the other frequency channels.
In this scenario, which three OFDM channels should be used? (Choose three.)

• A.13
• B.3
• C.1
• D.11
• E.6

Comment: *

Name: *

Email: *

Verification: *

What is the primary function of a Juniper Mist Edge when deployed for tunnel termination?

• A.To run the Marvis AI engine locally.
• B.To manage AP firmware upgrades.
• C.To provide a centralized point for terminating WLAN tunnels, keeping user traffic on the local network.
• D.To cache user data locally at the site.

Comment: *

Name: *

Email: *

Verification: *

You have deployed a Mist Edge cluster.
What happens to the tunneled client sessions if one of the Mist Edge nodes in the cluster fails?

• A.The APs automatically reboot and connect to the Mist cloud directly.
• B.Client sessions are statefully failed over to the remaining active node(s) in the cluster with minimal disruption.
• C.Only clients connected to APs that were terminating on the failed node lose connectivity.
• D.All clients lose connectivity and must re-authenticate.

Comment: *

Name: *

Email: *

Verification: *

Asset tracking using Mist-supported third-party BLE beacons has been installed in a warehouse. The BLE beacons were configured using their manufacturer-supplied configuration utility and BLE was properly configured for the site settings. When the warehouse floor plan is opened in Live View, the third-party beacons are not shown.
Which two statements describe causes for this issue? (Choose two.)

• A.The Show assets check box has not been selected in Live View.
• B.Marvis was not enabled for the site.
• C.The Locate this Client as an Asset check box has not been selected at the BLE client level.
• D.The APs are installed at 19 feet from the floor, above the recommended 15 feet.

Comment: *

Name: *

Email: *

Verification: *

Click the Exhibit button.

Referring to the exhibit, which statement is true?

• A.The WLAN is configured to use geofencing.
• B.The WLAN is configured to only broadcast on the 2.4 GHz spectrum.
• C.The WLAN is configured to use DFS channels.
• D.The WLAN is configured with the high-density data rate setting enabled.

Comment: *

Name: *

Email: *

Verification: *