A client connects to a wireless network, completes the 802.1X authentication, but then fails to obtain an IP address. The "Successful Connects" SLE shows a failure, and the primary classifier is "DHCP." Which two are the most likely causes for this specific failure? (Select all that apply.)
Correct Answer: C,D
Question 77
Click the Exhibit button. Referring to the exhibit, which percentage of connection attempts failed on the access point named LD_RS_Support?
Correct Answer: C
Question 78
Click the Exhibit button. Referring to the exhibit, in the USA, which two statements are correct? (Choose two.)
Correct Answer: A,D
Referring to the exhibit and considering that it is in the USA, the WLAN with SSID Eero1234 is not configured to industry best practices while the WLAN with SSID NETGEAR24 is configured to industry best practices.
Question 79
Which Juniper AP is used to augment BLE coverage?
Correct Answer: A
In the Juniper Mist AI product portfolio, the BT11 is a specialized, enterprise-grade access point designed exclusively for Bluetooth Low Energy (BLE).4 Unlike the other access points in the Juniper Mist family (such as the AP12, AP24, and AP34), the BT11 does not contain Wi-Fi radios.5 Its sole purpose is to provide high-accuracy, enterprise-grade location-based services (LBS) by leveraging Juniper's patented 16- element virtual BLE (vBLE) antenna array.6 The primary use case for the BT11 is to augment BLE coverage in environments where Wi-Fi connectivity is already established by other APs, but the density of those APs is insufficient for precise location services. For applications like turn-by-turn wayfinding or asset tracking, the RF requirements for BLE are often more stringent than those for Wi-Fi. A facility might have enough Wi-Fi APs to provide data coverage, but may have "location holes" where the BLE signals are too sparse for 1-3 meter accuracy. By deploying BT11 units in these gaps, administrators can extend the reach of the location engine without the expense of adding full- featured Wi-Fi radios where additional capacity is not needed.7 The BT11 communicates directly with the Mist Cloud to manage virtual beacons, which eliminate the need for physical, battery-powered beacons and manual calibration.8 Because it runs on Power over Ethernet (PoE) and integrates seamlessly with the Mist AI engine, it provides a scalable and cost-effective way to ensure continuous, high-fidelity BLE coverage across a campus, hospital, or retail floor.
Question 80
Which two statements are correct about Juniper Mist Dynamic Packet Capture? (Choose two.)
Correct Answer: A,B
Two correct statements about Juniper Mist Dynamic Packet Capture are that no configuration is necessary for Mist's Dynamic Packet Capture and it is automatically attached to a client event displayed on the Insights page. So the correct answers are A. No configuration is necessary for Mist's Dynamic Packet Capture and B. It is automatically attached to a client event displayed on the Insights page.
