Free Juniper JN0-480 Exam Dumps Questions & Answers

Exhibit.

In the EVPN-VXLAN data center fabric bridged overlay architecture shown in the exhibit, the servers are connected to Lead and Leat6 using the same virtual network identifier (VNI).
Which two statements are correct in this scenario? (Choose two.)

• A.  The underlay must be provisioned with PIMv2.
• B.  The underlay must use IRB interfaces.
• C.  The underlay EBGPpeering'smust be established between leaf and spine devices.
• D.  Loopback IPv4 addresses must be advertised into the EBGP underlay from leaf and spine devices.

You have designed your fabric in Juniper Apstra prior to deploying the network devices.
Which Apstra element in the Staged tab would be used to assist the team that is installing and cabling the devices?

• A.  Links table
• B.  Virtual Networks table
• C.  Connectivity Templates
• D.  Managed Devices list

Multilenancy for applications is achieved by creating virtual networks (VNs) within which construct?

• A.  routing table
• B.  connectivity template
• C.  routing zone
• D.  security policy

You must configure a static route for traffic to exit a configured routing zone. In the Juniper Apstra Ul. where would you accomplish this task?

• A.  under Staged -> Connectivity Templates
• B.  under Active -> Connectivity Templates
• C.  under Staged -> Virtual -> Routing Zones
• D.  under Active -> Virtual -> Routing Zones

You are adding a new switch to Juniper Apstra software. The Managed Devices page shows the "0 OS-Quarantined" status. What is the proper next step to make the device ready for use in a blueprint?

• A.  Take the device out of maintenance mode.
• B.  Acknowledge the device.
• C.  Take the device out of drain state.
• D.  Install the agent for the device.