In IS-IS advertising POUs with the overload bit has which effect?

• A.The ISIS adjacencies become passive
• B.The IS-IS adjacencies enter the "new" state
• C.The local device's POUs are marked with a metric of 65535
• D.The local device will no longer be used for transit traffic

Comment: *

Name: *

Email: *

Verification: *

The policy shown in the exhibit is applied as an export policy to your BGP neighborship.
Which action will be taken for route 12.233.45.5?

• A.It will be accepted by the default policy
• B.It will be evaluated by the next policy.
• C.It will be accomplished by term 1.
• D.It will be accepted by term 1.
• E.It will be rejected by term 2.

Comment: *

Name: *

Email: *

Verification: *

Your network has an unmanaged switch between the hosts and your EX Series switch. After the traffic enters the EX Series switch, each host must be on a separate VLAN.
How would you accomplish this task?

• A.Configure interface ge-0/0/3 to a mode trunk to assign the VLANs.
• B.Configure VSTP on interface ge-0/0/1 to assign the VLANs.
• C.Configure an output firewall filter on interface ge-0/0/1 to match the destination MAC or IP address of the hosts to assign the VLANs.
• D.Configure an input firewall filter on interface ge-0/0/3 to match the source MAC or IP address of the hosts to assign the VLANs.

Comment: *

Name: *

Email: *

Verification: *

Which two statements are correct regarding the behavior shown in the exhibit? (Choose two.)

• A.The router is an ABR.
• B.The ge-1/1/0 interface is configured as secondary for Area 0.
• C.The ge-1/1/0 interface is configured as secondary for Area 100.
• D.The router is not an ABR.

Comment: *

Name: *

Email: *

Verification: *

You are enabling MSTP in your Layer 2 network to prevent loops. In this scenario, which three parameters must match on all switches in the network? (Choose three. )

• A.bridge priority
• B.revision level
• C.configuration name
• D.MSTI-to-VLAN mapping
• E.max age

Comment: *

Name: *

Email: *

Verification: *