| Exam Code/Number: | JN0-661Join the discussion |
| Exam Name: | Service Provider Routing and Switching |
| Certification: | Juniper |
| Question Number: | 135 |
| Publish Date: | Sep 28, 2025 |
|
Rating
100%
|
|
-- Exhibit -
-- Exhibit --
Click the Exhibit button.
Each router in the exhibit is receiving three copies of the same IS-IS LSP from the other three routers in the topology. The additional copies of the IS-IS LSPs are causing additional processing overhead on each router. You want to reduce the overhead required to process the additional copies of the same IS-IS LSP.
Which feature accomplishes this task?
Click the Exhibit button.
You are using PIM-SM in your network and want to ensure that all available equal-cost paths are being used for multicast traffic.
Referring to the exhibit, where must you configure the PIM join-load-balance parameter to achieve this goal?
-- Exhibit -
-- Exhibit --
Click the Exhibit button.
The Client 1 router forwards a route learned from its EBGP peer to the route reflector RR1.
The route reflector forwards the route to the Client 2 router. However, the Client 2 router uses suboptimal routing to reach the EBGP route destination.
What would cause this behavior?
-- Exhibit -
-- Exhibit --
Click the Exhibit button.
Referring to the VPLS network shown in the exhibit, you notice that only one of the two CE sites configured under the VPLS instance forms a connection to the remote site. The other site remains in a forwarding and learning mode.
How does PE1 determine which CE within the VPLS instance forms the connection to the remote site?
-- Exhibit -
-- Exhibit --
Click the Exhibit button.
You administer the network shown in the exhibit. Routers R1, R3, and R4 are sending the same prefix to R2. All routers are using default local-preference values. You must make the prefix from R4 the most preferred.
Which two actions accomplish the task? (Choose two.)
