Free Juniper JN0-664 Exam Dumps Questions & Answers

Which two statements about IS-IS are correct? (Choose two.)

• A.  CSNPs are used to request a missing LSP.
• B.  CSNPs are used to acknowledge a received LSP.
• C.  PSNPs are used to acknowledge a received LSP.
• D.  PSNPs are used to request a missing LSP.

Which two statements are correct about IS-IS interfaces? (Choose two.)

• A.  If a broadcast interface is in both L1 and L2, separate hello messages are sent for each level.
• B.  If a point-to-point interface is in both L1 and L2, separate hello messages are sent for each level.
• C.  If a point-to-point interface is in both 11 and L2, one combined hello message is sent for both levels.
• D.  If a broadcast interface is in both L1 and L2, one combined hello message is sent for both levels.

Exhibit

Referring to the exhibit, which two statements are true? (Choose two.)

• A.  The devices advertising this route into EVPN are 10 0 2 12 and 10.0.2.22.
• B.  The device advertising this route into EVPN is 192.168.101.5.
• C.  This route is learned through EBGP
• D.  This is an EVPN Type-2 route.

Exhibit

Based on the configuration contents shown in the exhibit, which statement is true?

• A.  Joins for any group are accepted if the group count value is less than 25.
• B.  Joins for group 224.7.7.7 are rejected if the source address is 192.168.100.10
• C.  Joins for group 224.7.7.7 are accepted if the group count is less than 25
• D.  Joins for group 224.7.7.7 are always rejected, regardless of the group count.

After a recent power outage, your manager asks you to investigate ways to automatically reduce the impact caused by suboptimal routing in your OSPF and OSPFv3 network after devices reboot.
Which three configuration statements accomplish this task? (Choose three.)

• A.  set protocols ospf3 overload timeout 900
• B.  set protocols ospf overload
• C.  set protocols ospf3 overload
• D.  set protocols ospf overload timeout 900
• E.  set protocols ospf3 realm ipv4-unicast overload timeout 900