Free Juniper JN0-692 Exam Dumps Questions & Answers

R2 has an IBGP peering session with R1 but is not installing the expected external BGP routes. R1 has these same routes installed and they are active in its route table.
What are two reasons for this happening? (Choose two.)

• A.  local preference value
• B.  misconfigured policy
• C.  AS path loop
• D.  cannot reach next hop

PE-1 is not sending any routes to the CE router in the Cust routing instance.
What is the reason?

• A.  The as override parameter is causing an AS loop on the CE device.
• B.  The vrf-export policy must be explicitly defined.
• C.  There is a mismatch in the target community and the route distinguisher.
• D.  The vrf-import policy is only accepting direct routes.

What are two types of valid BGP messages? (Choose two.)

• A.  Open
• B.  Hello
• C.  Request
• D.  Notification

You are asked to configure an EBGP peering, but the peering does not establish and transitions between the Connect and Active states.
Referring to the exhibit, what is causing the problem?

• A.  BGP is waiting to receive a keepalive or notification message from the peer.
• B.  The number of messages from the BGP peer has exceeded the receive socket buffer.
• C.  The BGP peer has an incorrect address configured, causing a connectivity failure.
• D.  An incorrect local AS has been configured in the BGP group configuration.

Click the Exhibit button.
-- Exhibit -
[edit]
user@router# show protocols bgp
group myEBGP {
import noTransit;
peer-as 318;
neighbor ;
}
[edit] user@router# show policy-options
policy-statement noTransit { term rejectAS1524 { from as-path AS1524; then accept; }
} as-path AS1524 *1524*; -- Exhibit -
To block transit traffic from AS1524, you have configured and committed the configuration as shown in the exhibit. However, traffic from AS1524 is still flowing through your AS.
Which two changes must you implement to resolve the problem? (Choose two.)

• A.  Change the import noTransit statement to export noTransit.
• B.  Change the then condition from accept to reject.
• C.  Change the as-path regex to ".* 1524 .*"
• D.  Change the peer AS in the myEBGP group to 1524.