Free Microsoft 70-743 Exam Dumps Questions & Answers

You implement a Windows Server 2016 failover cluster named Cluster1 as a highly available file server.
You run the Get-Cluster cmdlet and receive the following output.

Use the drop-down menus to select the answer choice that completes each statement based on the information presented in the graphic.

Correct Answer:

You have a server named Server1 that runs Windows Servers 2016. Server1 has a storage array that contains multiple storage enclosures. The storage hardware supports enclosure awareness.
You need to implement Storage Spaces on Server1. Storage Spaces must remain available if two enclosures fail. The solution must minimize the number of enclosures required and must provide the fastest possible write performance.
Which configurations should you use? To answer, select the appropriate options in the answer area.
NOTE: Each correct selection is worth one point.

Correct Answer:

Explanation

References:
https://docs.microsoft.com/en-us/windows-server/storage/storage-spaces/storage-spaces-fault-tolerance#summar

You have a server named Served that runs Windows Server 2016. Server1 will be used as a VPN server. You need to configure Server1 to support VPN Reconnect. Which VPN protocol should you use?

• A.  PPTP
• B.  SSTP
• C.  lKEv2
• D.  L2TP

Note: This question is part of a series of questions that use the same or similar answer choices. An answer choice may be correct for more than one question in the series. Each question is independent of the other questions in this series. Information and details provided in a question apply only to that question.
Your network contains Windows and non-Windows devices.
You have a DHCP server named Server1 that has an IPv4 scope named Scope1.
You need to prevent a client computer that uses the same name as an existing registration from updating the registration.
What should you do?

• A.  From Control Panel, modify the properties of Ethernet.
• B.  From IPv4, create a new filter.
• C.  From the properties of Scope1, modify the Conflict detection attempts setting.
• D.  From the properties of Scope1, create an exclusion range.
• E.  From IPv4 run the DHCP Policy Configuration Wizard.
• F.  From Scope1, create a reservation.
• G.  From the properties of IPv4, configure the bindings.
• H.  From the properties of Scope1, configure Name Protection.

You have a five-node failover cluster named Cluster1. All the nodes run Windows Server 2012 R2. All the nodes run on physical hardware. You need to upgrade Cluster1 to Windows Server 2016.
The solution must minimize administrative effort and <0StS. What should you do fast?

• A.  Add a Windows Server 2016 node to Cluster 1.
• B.  Enable cluster-Aware updating (CAU) on Cluster1.
• C.  CreateanewWlndowsServer2016failovercluster.
• D.  Drain and evict a node from Clusterl1.