You have an Azure IoT Central application.
You need to connect an IoT device to the application.
Which two settings do you require in IoT Central to configure the device? Each correct answer presents part of the solution.
NOTE: Each correct selection is worth one point.

• A.Group SAS Primary Key
• B.the IoT hub name
• C.Scope ID
• D.Application Name
• E.Device ID

Correct Answer: C,E

In your Azure IoT Central application, add a real device to the device template
1. On the Devices page, select the Environmental sensor device template.
2. Select + New.
3. Make sure that Simulated is Off. Then select Create.
Click on the device name, and then select Connect. Make a note of the device connection information on the Device Connection page - ID scope, Device ID, and Primary key. You need these values when you create your device code:

Reference:
https://docs.microsoft.com/bs-cyrl-ba/azure/iot-central/core/tutorial-connect-device-python

Comment: *

Name: *

Email: *

Verification: *

You need to recommend the format of telemetry messages to meet the POV requirements.
What should you recommend?

• A.XML
• B.Avro
• C.JSON

Comment: *

Name: *

Email: *

Verification: *

Note: This question is part of a series of questions that present the same scenario. Each question in the series contains a unique solution that might meet the stated goals. Some question sets might have more than one correct solution, while others might not have a correct solution.
After you answer a question in this section, you will NOT be able to return to it. As a result, these questions will not appear in the review screen.
You are developing a custom Azure IoT Edge module.
The module needs to identify the device ID of the local device.
Solution: You configure the module to read the ProductInfo property of ModuleClient.
Does this meet the goal?

• A.Yes
• B.No

Comment: *

Name: *

Email: *

Verification: *

You have an Azure IoT solution.
You need to test that the solution remains functional if IoT Hub is affected by a regional outage.
What should you do?

• A.From the loT hub, set Allow public network access to Disabled.
• B.From the loT hub, start a manual failover.
• C.From the Device Provisioning Service (DPS), unlink the loT hub.
• D.From the loT hub, select Disable fallback route.

Comment: *

Name: *

Email: *

Verification: *

You have an Azure IoT Edge module named SampleModule that runs on a device named Device1.
You make changes to the code of SampleModule by using Microsoft Visual Studio Code.
You need to push the code to the container registry and then deploy the module to Device1.
Which two actions should you perform from Visual Studio Code? Each correct answer presents part of the solution.
NOTE: Each correct selection is worth one point.

• A.Build and push the SampleModule code to the registry.
• B.Create a deployment for a single device.
• C.Generate a deployment manifest.
• D.Build an loT Edge solution.
• E.Generate a shared access signature (SAS) token for Device 1.

Comment: *

Name: *

Email: *

Verification: *