You have a server that runs Windows Server 2025 Standard and has the Hyper-V role installed. You need to upgrade the server to Windows Server 2025 Datacenter. The solution must minimize downtime. What should you run?
You have a Windows Server 2022 failover cluster named Cluster1 that contains the Cluster Shared Volumes (CSV) shown in the following table.
All the nodes in Cluster1 have BitLocker Drive Encryption (BitLocker) installed.
You need to use PowerShell to enable BitLocker on Volume1.
In which order should you run the commands? To answer, drag the appropriate commands to the correct order. You may need to drag the split bar between panes or scroll to view content.
NOTE Each correct selection is worth one point.
Your on-premises network contains two subnets. The subnets contain servers that run Windows Server as shown in the following table.
Server4 has the following IP configurations:
Ethernet adapter Ethernet:
Connection-specific DNS Suffix.:
IPv4 Address . . . . . . . . . . . : 192.168.0.10
Subnet Mask . . . . . . . . . . . : 255.255.255.0
Default Gateway . . . . . . . . . : 192.168.0.1
From Server4, you can ping Server1 and Server2 successfully. When you ping Server3, you get a Request timed out response.
From Server2, you can ping Server1 and Server3 successfully.
The misconfiguration of which component on Server3 can cause the Request timed out response?
Your network contains an Active Directory Domain Services (AD DS) domain. The domain contains a failover cluster named Cluster1.
You need to configure Cluster-Aware Updating (CAU) on the cluster by using Windows Admin Center (WAC).
Which three actions should you perform in sequence? To answer, move the appropriate actions from the list of actions to the answer area and arrange them in the correct order.
Note: This question is part of a series of questions that present the same scenario. Each question in the series contains a unique solution that might meet the stated goals. Some question sets might have more than one correct solution, while others might not have a correct solution.
After you answer a question in this section, you will NOT be able to return to it. As a result, these questions will not appear in the review screen.
You have a failover cluster named Cluster1 that hosts an application named App1.
The General tab in App1 Properties is shown in the General exhibit. (Click the General tab.)
The Failover tab in App1 Properties is shown in the Failover exhibit. (Click the Failover tab.)
Server1 shuts down unexpectedly.
You need to ensure that when you start Server1, App1 continues to run on Server2.
Solution: You increase Maximum failures in the specified period for the App1 cluster role.
Does this meet the goal?
