FreeQAs
 Request Exam  Contact
  • Home
  • View All Exams
  • New QA's
  • Upload
PRACTICE EXAMS:
  • Oracle
  • Fortinet
  • IBM
  • Juniper
  • Microsoft
  • Cisco
  • Citrix
  • CompTIA
  • VMware
  • ISC
  • SAP
  • EMC
  • PMI
  • HP
  • Salesforce
  • Other
  • Oracle
    Oracle
  • Fortinet
    Fortinet
  • IBM
    IBM
  • Juniper
    Juniper
  • Microsoft
    Microsoft
  • Cisco
    Cisco
  • Citrix
    Citrix
  • CompTIA
    CompTIA
  • VMware
    VMware
  • ISC
    ISC
  • SAP
    SAP
  • EMC
    EMC
  • PMI
    PMI
  • HP
    HP
  • Salesforce
    Salesforce
  1. Home
  2. MikroTik Certification
  3. MTCNA Exam
  4. MikroTik.MTCNA.v2025-06-23.q150 Dumps
  • «
  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • …
  • »
  • »»
Download Now

Question 21

Select valid MAC-address:

Correct Answer: B
A valid MAC address must meet the following criteria:
* Be 6 bytes (48 bits) in length
* Consist of only hexadecimal digits (0-9, A-F)
* Written in six groups separated by colons or hyphens (e.g., 00:1A:2B:3C:4D:5E) MTCNA Course Material - RouterOS MAC Address Basics:
"MAC addresses are 48-bit identifiers written as six pairs of hexadecimal digits. Invalid characters or incorrect length disqualifies an address." Rene Meneses MTCNA Guide - MAC Addressing Section:
"Each MAC is made up of 12 hexadecimal characters (6 octets). If a character like 'G' appears, or if it's longer than 6 bytes, it is invalid." MikroTik Wiki - MAC Addressing Rules:
"Valid MAC format: XX:XX:XX:XX:XX:XX using only 0-9 and A-F. 192.168.0.0/16 is an IP subnet, not a MAC."
* Option A: Invalid - "G" and "H" are not hexadecimal characters
* Option B: Valid - proper format and hex content
* Option C: Invalid - Too long (appears to be IPv6 or malformed)
* Option D: Invalid - this is an IP network (CIDR notation), not a MAC
Only Option B is correct.
insert code

Question 22

When using routing option 'check-gateway=ping' after how many timeouts is gateway considered unreachable:

Correct Answer: C
insert code

Question 23

What configuration is added by /ip Hot-Spot setup command? (select all that apply)

Correct Answer: C,D
insert code

Question 24

Which default route will be active?
/ip route
add disabled=no distance=10 dst-address=0.0.0.0/0 gateway=1.1.1.1
add disabled=no distance=5 dst-address=0.0.0.0/0 gateway=2.2.2.2

Correct Answer: A
In MikroTik RouterOS (and in routing in general), the "distance" value determines the priority of a route. The route with the lowest distance will be preferred.
Here:
* Route to 0.0.0.0/0 via 1.1.1.1 has distance = 10
* Route to 0.0.0.0/0 via 2.2.2.2 has distance = 5 # lower, so preferred# Unless the lower-distance route is invalid or unreachable, it will always be selected.
MTCNA Course Manual - Static Routing:
"The lower the distance value, the higher the route's priority. Routes are selected based on administrative distance first." Rene Meneses Study Guide - Route Distance:
"A route with distance 1 is preferred over a route with distance 2. It does not matter which was added first." Terry Combs Notes - Routing Behavior:
"RouterOS evaluates the distance (priority) before anything else. Smallest value wins."
insert code

Question 25

What is the correct action to be specified in the NAT rule to hide a private network when communicating to the outside world?

Correct Answer: D
insert code
  • «
  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • …
  • »
  • »»
[×]

Download PDF File

Enter your email address to download MikroTik.MTCNA.v2025-06-23.q150 Dumps

Email:

FreeQAs

Our website provides the Largest and the most Latest vendors Certification Exam materials around the world.

Using dumps we provide to Pass the Exam, we has the Valid Dumps with passing guranteed just which you need.

  • DMCA
  • About
  • Contact Us
  • Privacy Policy
  • Terms & Conditions
©2026 FreeQAs

www.freeqas.com materials do not contain actual questions and answers from Cisco's certification exams.