If inspectors identify issues of non-conformance during an inspection, they should

• A.wait until the final report is being prepared to identify the issues in writing so they are fully documented
• B.perform additional tests secretly to ensure there are no other potential issues at the site
• C.instruct the contractor's personnel in how to correct the issue so the project is not delayed
• D.inform both the Contractor and the inspector's supervisor so they can take appropriate corrective actions

Comment: *

Name: *

Email: *

Verification: *

Non Conformance Reports are completed by the Inspector:

• A.When the Inspector and Contractor deem it to be a significant non-conforming item
• B.In every instance that an item does not meet the specification requirements
• C.When the Inspector deems it to be a significant non-conforming item
• D.In accordance with the specification's definition of a non-conformance

Comment: *

Name: *

Email: *

Verification: *

An exposed area of the substrate or previous coat of a conductive coating material, often caused by poor application technique is called

• A.holiday.
• B.checking.
• C.cracking.
• D.sagging.

Comment: *

Name: *

Email: *

Verification: *

Solvents are added to coating formulations to

• A.dissolve binders and form liquid coatings.
• B.provide color.
• C.increase film permeability.
• D.decrease film permeability.

Comment: *

Name: *

Email: *

Verification: *

Osmotic blistering is most likely to occur as a result of

• A.applying tine coating too thin.
• B.inadequate anchor pattern/surface profile.
• C.overcoating a surface contaminated with chemical salts.
• D.airless spray application

Comment: *

Name: *

Email: *

Verification: *