Upon arrival of coating materials, the inspector should

• A.observe and document time frame and environmental conditions between each coat.
• B.observe aryl document that the applicator WFT at regular intervals during application.
• C.review coating contractors' plans for storage of coating materials and confirm they meet national, local and owners' fire and environmental regulations.
• D.observe and document the amount of material and batch numbers.

Comment: *

Name: *

Email: *

Verification: *

Fine cracks in the surface of a coating that rarely reach the substrate are called

• A.checking.
• B.alligatoring.
• C.cracking.
• D.blistering.

Comment: *

Name: *

Email: *

Verification: *

When working as a NACE Inspector in a situation where there is a difference of opinion, the Inspector needs to:

• A.Go with the majority opinion
• B.Achieve consensus through negotiation
• C.Never change his/her mind
• D.Call the supervisor

Comment: *

Name: *

Email: *

Verification: *

SSPC SP 1 identifies the use of:

• A.Biodegradable detergents
• B.Organic solvents
• C.Inorganic solvents
• D.A wide variety of materials

Comment: *

Name: *

Email: *

Verification: *

A single application coating film has a measured dry film thickness (DFT) between 4 and 5 mils (between 100 and 125 microns). The volume solids of the coating immediately before application were 67%, What wet film thickness (WFT) was applied?

• A.6 to 7 mils (150 to 175 microns)
• B.5 to 6 mils (125 to 150 microns)
• C.8 to 10 mils (200 to 250 microns)
• D.10 to 12 mils (250 to 300 microns)

Comment: *

Name: *

Email: *

Verification: *