Free Access to NetworkAppliance.NS0-184.v2024-08-23.q44 with Valid Practice Test (Page 2)

Question 1

After adding two nodes to an FC-enabled cluster, the storage administrator wants to ensure that existing LUNs can use paths on the new nodes.
What is required to complete this task?

A.Use the lun bind create command.
B.Rescan the bus on the hosts by using the rescan-scsi-bus.sh script.
C.Use the storage port rescan command.
D.Use the lun mapping add-reporting-nodes command.

Question 2

Your customer is migrating data from a legacy FAS8020 system that runs ONTAP 9.5 software to a new AFF A250 MetroCluster over IP configuration.
In this scenario, which two methods would be supported to migrate the data? (Choose two.)

A.Use a host-based copy migration method.
B.Configure a SnapMirror copy between the FAS8020 and the AFF A250 systems.
C.Create a 4-node cluster on one side and use the vol move command to migrate the data.
D.Perform a controller swap from the FAS8020 to the AFF A250s.

Question 3

You have a 2-node FAS8300 switchless ONTAP 9.8 cluster that serves NAS volumes. You have a data SVM that connects to the network using multimode LACP with VLAN tags.
In this scenario, which front-end FAS8300 network port would you create the data LIFs?

A.a0a-100
B.e0e-100
C.a0a
D.e0e

Question 4

What should you do to change the data protocol of a LIF?

A.Delete and re-recreate the LIF.
B.Put the LIF in another broadcast domain.
C.Add the new data protocol to the LIF.
D.Shut down the assigned port.

Question 5

Click the Exhibit button.

You are reviewing the setup of a recently installed FAS9000 switched cluster. As shown in the exhibit, the cluster interconnects are connected to a pair of Cisco Nexus 3132Q-V 40 Gb ports.
For a high availability, which ports should swap Ethernet cables?

A.Swap node1:e4a and node1:e8a.
B.Swap node2:e4a and node2:e8a.
C.Swap node1:e8a and node2:e4a.
D.Swap node1:e4a and node2:e4b.

Question 1

Question 2

Question 3

Question 4

Question 5

Download PDF File