A customer is concerned because an external tool is reporting 100% CPU utilization on node "netapp-01". There are no reports of latency or throughput issues. You execute some commands and obtain the output shown in the exhibit.
Based on the output, you see no problems. In this scenario, what are two reasons that support your position? (Choose two.)

• A.the amount of read network throughput is below 200 MB/sec
• B.the consistency points are type T
• C.average CPU utilization is below 50%
• D.the low number of CIFS operations

Comment: *

Name: *

Email: *

Verification: *

A customer is showing disk utilization is at 100% in Active IQ even though there are low protocol operations on the controller. You review the data shown in the exhibit.

In this situation, what should you do?

• A.Reseat shelf module B.
• B.Replace disk 6b.39.
• C.Replace disks 6b.34 and 6a.19.
• D.Add disks to the aggregate to bring down the average utilization.

Comment: *

Name: *

Email: *

Verification: *

Exhibit:








Which two steps would you perform to correct the problem shown in the exhibit? (Choose two.)

• A.Replace the shelf chassis.
• B.Reseat the power supplies.
• C.Reseat the shelf modules.
• D.Perform a takeover and giveback.

Comment: *

Name: *

Email: *

Verification: *

In ONTAP 9.5, the event log show command queries and displays entries from which file?

• A.ems.log
• B.bcomd.log
• C.mgwd.log
• D.messages.log

Comment: *

Name: *

Email: *

Verification: *

You need to provide a customer an action plan to update an ONTAP system after a security bulletin has been issued.
In this scenario, how do you accomplish this task?

• A.Download the target version and do a pre-check.
• B.Use Upgrade Advisor on Active IQ.
• C.Use the Interoperability Matrix Tool.
• D.Review the ONTAP 9 product page.

Comment: *

Name: *

Email: *

Verification: *