You log in to a SnapMirror destination to review the system.
Which scanner would you expect to see running?

• A.container block reclamation
• B.blocks used summary update
• C.active bitmap real management
• D.deswizzler

Comment: *

Name: *

Email: *

Verification: *

Which statement is correct for a mirrored aggregate?

• A.The aggregate has a RAID group that is double reconstructing.
• B.The aggregate is being copied.
• C.The aggregate is configured with SnapMirror.
• D.The aggregate is configured with SyncMirror.

Comment: *

Name: *

Email: *

Verification: *

Exhibit:

A customer receives the AutoSupport message shown below.
''(?] Sat Aug 23 13:00:27 PDT [hostname: env_rngr: callhome.c.fan.fru.fault:error] :
Call home for CHASSIS FAN FRU FAILED: SysFan3 F2 (?] Sat Aug 23 13:00:32
PDT [hostname: env_mgr: monitor.chassisFan.ok:notice]: Chassis fan Sysfan3 F2 is ok"
The output of the sysconfig -a command is shown in the exhibit.
In this scenario, what would you do to solve this problem?

• A.Update Data ONTAP to 8.1.4 at the latest patch level.
• B.Disconnect the controller from the mains, wait two minutes, and re-connect it in the next maintenance window.
• C.Replace the fan.
• D.Update the Service Processor firmware.

Comment: *

Name: *

Email: *

Verification: *

A customer will need to perform an upgrade from 9.0 to 9.4.
Which feature of ONTAP enables nondisruptive hardware maintenance for this upgrade?

• A.RAID-TEC
• B.aggregate relocation
• C.FlexVol
• D.FlexGroup

Comment: *

Name: *

Email: *

Verification: *

Exhibit:

A customer receives the AutoSupport message shown below.
''(?] Sat Aug 23 13:00:27 PDT [hostname: env_rngr: callhome.c.fan.fru.fault:error] :
Call home for CHASSIS FAN FRU FAILED: SysFan3 F2 (?] Sat Aug 23 13:00:32
PDT [hostname: env_mgr: monitor.chassisFan.ok:notice]: Chassis fan Sysfan3 F2 is ok"
The output of the sysconfig -a command is shown in the exhibit.
In this scenario, what would you do to solve this problem?

• A.Update Data ONTAP to 8.1.4 at the latest patch level.
• B.Replace the fan.
• C.Update the Service Processor firmware.
• D.Disconnect the controller from the mains, wait two minutes, and re-connect it in the next maintenance window.

Comment: *

Name: *

Email: *

Verification: *