You notice poor performance on your FlexGroup and execute the system node run -node * flexgroup show command for more Information. You notice the "Urge" column has non-zero values.
In this scenario, which statement is true?

• A.The data placement is uneven.
• B.The constituent volumes are out of Inodes.
• C.The aggregate is completely full.
• D.The constituent volumes are completely full.

Comment: *

Name: *

Email: *

Verification: *

You want to assign storage access to an NVMe protocol host.
Which three objects must beconfigured to accomplish this task? (Choose three.)

• A.an NVMe LIF
• B.the NVMe subsystem
• C.an NVMe LUN
• D.the NVMe broadcast domain
• E.the NVMe namespace

Comment: *

Name: *

Email: *

Verification: *

Your customer is running a NetApp AFF A800 system with NetAppONTAP 9.8 software and states that their
NS224 shelf is not showing with the correct shelf ID. You analyze the data and the shelf shows an
identification of "1.SHFHUXXXXXXXXXX."
What is the cause of the reported Issue?

• A.A new shelf was added to the controller.
• B.The shelf was cabled Incorrectly.
• C.The shelf has been power cycled.
• D.The shelf had a disk replaced too quickly.

Comment: *

Name: *

Email: *

Verification: *

Your customer Informs you about SnapMlrror problems after upgrading NetApp ONTAP software to a newer
version. After investigating the event logs and the SnapMirror history, you see information about delayed
updates of the SnapMirror relationships.
How would your customer prevent such problems in the future?

• A.Delete the SnapMirror relationships and create them new after upgrading the ONTAP software.
• B.Verify that the cabling of the hardware port that Is responsible for SnapMirror transfers Is correct.
• C.Quiesce the SnapMirror relationships before upgrading the ONTAP software.
• D.Modify the schedules of the SnapMirror relationships after upgrading the ONTAP software.

Comment: *

Name: *

Email: *

Verification: *

A customer wants to connect a NetApp AFF A700 system to a 40GbE switch. The controllers have a 10/40G
Ethernet card in slot 4 for this purpose. The link comes up fine on node 2,but it will not come up on node 1.
You look at the AutoSupport data for the nodes in question and see the output shown in the exhibit.

What is the cause of the customer's problem?

• A.The cable is plugged in upside down.
• B.The incorrect cable is used.
• C.The port has an incorrect SFP inserted.
• D.The ports are configured for 4x10Gbit instead of 40Gbit.

Comment: *

Name: *

Email: *

Verification: *