Free Network Appliance NS0-094 Exam Dumps Questions & Answers

Which two scenarios are common causes of the root volume needing root volume recovery?
(Choose two.)

• A.  The mainboard was replaced following a Non-Maskable Interrupt (NMI) panic.
• B.  Root volume migrate was performed.
• C.  The cluster configuration is out of sync on the volume.
• D.  The root volume ran out of space.

A Field Support engineer has just replaced the motherboard of one of the controllers in a NetApp ONTAP cluster. The node is recovered, but ONTAP software will not perform a giveback. After investigating, you determine that you are using self-encrypting FIPS drives. The failure is that the Onboard Key Manager is unable to synchronize. The passphrase has been misplaced or forgotten. Which action do you take to correct the failure while leaving the data intact?

• A.  Use the volume encryption rekey start command.
• B.  Use the storage encryption disk modify command.
• C.  Use the storage encryption disk destroy command.
• D.  Use the storage encryption disk sanitize command.

What are the two steps to unfail a disk in maintenance mode? (Choose two.)

• A.  Use the disk remove command.
• B.  Reseat the disk.
• C.  Remove it from the Failed Disk Registry.
• D.  Use the "disk unfair command.

In which two sections of AutoSupport can you find information to analyze the following panic?
(Choose two.)
Panic_Message: PCI Error NMI from
device(s):ErrSrcID(CorrSrc(0xf00),UCorrSrc(0x18)), RPT(0,3,0):Qlogic FC
16G adapter in slot 1 on Controller

• A.  SSRAM-LOG
• B.  HA-RASTRACE.TGZ
• C.  ALL-COREDUMP.XML
• D.  PCI-HIERARCHY.XML

You are performing a head swap to upgrade your NetApp ONTAP controllers. After completing the first controller upgrade, the new controller does not show any cluster ports, and the new controller cannot communicate with the rest of the cluster. You verified that the new controller is cabled correctly, and swapped the cables, yet the ports still do not show. Which action resolves the issue and enables the new controller to communicate with the cluster?

• A.  Create new cluster interfaces, and add the interfaces to the cluster broadcast domain.
• B.  Create new network ports, then create new cluster interfaces and add them to the cluster broadcast domain.
• C.  Modify the network ports, and modify the cluster interfaces to the cluster broadcast domain.
• D.  Modify the cluster interfaces, and add the interfaces to the cluster broadcast domain.