Referring to the exhibit.

A customer receives "CLUSTER NETWORK DEGRADED" AutoSupport messages from this clustered Data ONTAP system. The customer suspects that something occurred physically to the nodes after they had a data center maintenance move.
The customer proceeds to follow the instructions in the Knowledge Base article regarding the "Error: CLUSTER NETWORK DEGRADED" message that results in the output shown In the exhibit.
After analysis, the customer decides to replace the small form-factor pluggable (SFP) transceivers and the cables on the system.
Which statistic supports the customer's analysis?

• A.Jumbo frames
• B.BCast pkts
• C.CRC errors
• D.Multi/broadcast

Comment: *

Name: *

Email: *

Verification: *

Referring to the exhibit.

A customer receives "CLUSTER NETWORK DEGRADED" AutoSupport messages from this clustered Data ONTAP system. The customer suspects that something occurred physically to the nodes after they had a data center maintenance move.
The customer proceeds to follow the instructions in the Knowledge Base article regarding the "Error: CLUSTER NETWORK DEGRADED" message that results in the output shown In the exhibit.
After analysis, the customer decides to replace the small form-factor pluggable (SFP) transceivers and the cables on the system.
Which statistic supports the customer's analysis?

• A.BCast pkts
• B.CRC errors
• C.Jumbo frames
• D.Multi/broadcast

Comment: *

Name: *

Email: *

Verification: *

In clustered Data ONTAP, you just configured a new storage virtual machine (SVM) that SnapCenter Plug-in for Microsoft Windows needs to access to create Snapshot copies when running SnapManager for Microsoft Exchange Server.
However, when attempting to configure the SnapDrive transport protocol settings to communicate with the SVM, you receive the error shown in the exhibit.
Which three parameters are required in this scenario? (Choose three.)

• A.The SVM name is the same as the CIFS server name when CIFS is enabled.
• B.The SVM name resolves to the management LIF's IP address.
• C.The role is set to cluster.
• D.The SVM management LIF firewall policy is set to management.
• E.The data protocol is set to "none."

Comment: *

Name: *

Email: *

Verification: *

A customer has replaced both interconnect cables on a FAS3240 HA pair with IOXM because they were damaged. After replacing the cables, the customer receives the error shown below.
"HA interconnect port 1 of this appliance seems to be connected to port 2 on the partner appliance." In this scenario what is the cause of this error?

• A.c0a and c0b are 10Gbit Ethernet ports which must not be used for the interconnect.
• B.The interconnect cables must not be replaced while the controllers are up and running.
• C.You must issue the if config down . . . command followed by the if config up ... command for both ports, on both controllers, after replacing the cables.
• D.The interconnects are cross-cabled, you must connect c0a with c0a and c0b with c0b.

Comment: *

Name: *

Email: *

Verification: *

Click the Exhibit button at the right.
A customer reports that a node panicked due to a multidisk failure.
While in take over, the customer reviewed the output of the sysconfig -a command and noticed a discrepancy in the shelf stack as shown in the exhibit.

The customer proceeded to examine the power supplies in the stack of shelves; all were functional.
Which step would you take to solve this problem?

• A.Reseat all the disks in shelf 1.
• B.Replace the SAS cable from adapter 2d to shelf 1.
• C.Replace the shelf chassis of shelf 1.
• D.Replace the motherboard in the broken node.

Comment: *

Name: *

Email: *

Verification: *