Free Network Appliance NS0-516 Exam Dumps Questions & Answers

Which E-Series management interface provides a command-line scripting capability for automating repetitive configuration and monitoring tasks across multiple arrays?

• A.  SANtricity Storage Manager's Script Engine / SMcli (Command Line Interface)
• B.  SANtricity System Manager GUI only
• C.  Performance tab exports only
• D.  Recovery Guru

During installation of an EF600 all-flash array, the installer notices that write performance is lower than expected even though NVMe drives are installed. Which configuration item is most likely the cause?

• A.  The volumes are configured as thin-provisioned
• B.  Drive Security (FDE) is enabled
• C.  The array is using SAS-attached expansion shelves instead of NVMe-oF
• D.  Automatic Load Balancing is disabled

You help a customer diagnose a performance issue on an E-Series storage system. You decide to measure the amount of data that is being handled over the span of an hour. In this scenario, what are you measuring?

• A.  IOPS
• B.  parity
• C.  I/O alignment
• D.  throughput

The NetApp E-Series system with a 32 Gb FC Host Interface Card (HIC) requires which type of fiber cable to connect to switches or to connect directly to hosts extending up to 100 meters?

• A.  OM2
• B.  OM1
• C.  OM4
• D.  OM3

You are adding drives to an existing Dynamic Disk Pool (DDP). In this scenario, which two drive characteristics should you consider when selecting the drives? (Choose two.)

• A.  if the drives have a compatible security type
• B.  if the drives are the same capacity or larger
• C.  if the drives are from the same manufacturer
• D.  if the drives have the same firmware level