When a drive fails in a Dynamic Disk Pool (DDP) with no free capacity, what happens to the data?

• A.It is rebuilt using the on-board backup database
• B.It is evacuated to the preservation capacity within the DD
• C.It is rebuilt using preservation capacity within the DD
• D.It is evacuated to a hot spare drive that is assigned to the DD

Comment: *

Name: *

Email: *

Verification: *

A customer is running several EF570 systems and uses the ability of the EF-Series systems to run two host protocols at the same time. You are installing a new EF570 that uses the NVMe protocol for a high performance computing application. The controller on-board ports will not connect, but the HIC ports are working fine.
In this scenario, what is the problem?

• A.The on-board ports have the wrong SFPs for the desired network protocol
• B.The on-board host ports are disabled
• C.There is a cable fault preventing the on-board ports from connecting
• D.The switch ports are shut-down

Comment: *

Name: *

Email: *

Verification: *

During a routine review of firewall logs, an analyst identified that an IP address from the organization's server subnet had been connecting during nighttime hours to a foreign IP address, and had been sending between 150 and 500 megabytes of data each time. This had been going on for approximately one week, and the affected server was taken offline for forensic review.
Which of the following is MOST likely to drive up the incident's impact assessment?

• A.The local root password for the affected server was compromised.
• B.IP addresses and other network-related configurations were exfiltrated.
• C.Forensic review of the server required fall-back on a less efficient service.
• D.PII of company employees and customers was exfiltrated.
• E.Raw financial information about the company was accessed.

Comment: *

Name: *

Email: *

Verification: *

Which sequence describes the procedures for hot-adding an additional expansion enclosure to an existing E-Series configuration? (Choose the best answer.)

• A.Power on expansion enclosure, add one ESM cable between it and another available expansion port, check SANtricity for addition of the new enclosure, disrupt the other SAS connection to add second cable
• B.Add one ESM cable between it and another available expansion port, disrupt the other SAS connection to add second cable, check SANtricity for addition of the new enclosure, power on expansion enclosure.
• C.Add one ESM cable between it and another available expansion port, disrupt the other SAS connection to add second cable, power on expansion enclosure, check SANtricity for addition of the new enclosure.
• D.Power on expansion enclosure,add one ESM cable between it andanother available expansion port, disrupt the other SAS connection to add second cable, check SANtricity for addition of the new enclosure.

Comment: *

Name: *

Email: *

Verification: *

Exhibit:

Referring to the exhibit, which cable is an InfiniBand 4X connector?

• A.1
• B.2
• C.3
• D.4

Comment: *

Name: *

Email: *

Verification: *