Exhibit.

The VMware ESX host discovers only two of four paths to a LUN on a new ONTAP cluster.
Referring to the exhibit, which statement Is correct?

• A.The igroup does not contain the. WWPN of one initiator.
• B.The fabric zoning configuration does not allow access to the target LlFs.
• C.The fabric name server is disabled.
• D.The initiator HBA is not connected to the fabric.

Comment: *

Name: *

Email: *

Verification: *

You have an existing 2-node AFF A300 cluster with premium bundle licensing applied. You need to have consistently low front end latency, and have determined that NVMe satisfies this requirement.
Referring to the exhibit, which two actions would accomplish this task? (Choose two.)

• A.Add a UTA2 adapter to each of the two AFF A300 nodes.
• B.Apply the license for FCP.
• C.Apply the license for NVMe.
• D.Add a 32 GB FC HBA to each of the two AFF A300 nodes.

Comment: *

Name: *

Email: *

Verification: *

An administrator is configuring their existing Ethernet network switches to provide ISCSI LUNs to several servers. The network switches are also used for other traffic from various hosts. In this scenario, which statement is true?

• A.Increase the ratio of access ports to trunk ports to 2:1
• B.Configure the MTU size to be larger on the switch and storage than on the host.
• C.Use multiple VLANs to isolate traffic from other network traffic
• D.Netapp recommends using the same LIFs for NFS and ISCSI traffic

Comment: *

Name: *

Email: *

Verification: *

Automatic host-side space management with SCSI T10 thin-provisioned LUNs is achieved by which feature of ONTAP?

• A.volume auto-grow
• B.fractional reserve
• C.space allocation
• D.space reservation

Comment: *

Name: *

Email: *

Verification: *

You are setting up FC ports and must configure the speeds for both the SAN and the host ports. In this scenario, which statement is correct?

• A.Set the target port speed to match the switch port speed.
• B.Set the target port speed higher than the switch port speed.
• C.Set the target port speed to auto-negotiation.
• D.Set the target port speed lower than the switch port speed.

Comment: *

Name: *

Email: *

Verification: *