Exhibit.

Referring to the exhibit, which FC LIF would cause a path failure on a host connecting to a LUN?

• A.fcp_sanluns01prod02p0e
• B.fcp_sanluns01prod02p0g
• C.fcp_sanluns01prod02p0g
• D.fcp_sanluns0lptodOlp0e

Comment: *

Name: *

Email: *

Verification: *

You create a new iSCSI SVM and secure iSCSI sessions by using both Challenge-Handshake Authentication Protocol (CHAP) and iSCSI Access Control Lists (ACL).
In this scenario, in which two ways are you securing your iSCSI implementation? (Choose two.)

• A.iSCSI ACLs are applied to the initiator configuration to provide an IP address of the targets.
• B.iSCSI ACLs are applied to the target configuration to provide an IP address of the initiators.
• C.CHAP encrypts all iSCSI session I/O.
• D.CHAP creates a hash value for the username and shared secret.

Comment: *

Name: *

Email: *

Verification: *

You are asked to serve iSCSI LUNs in an existing SVM on your AFF A220 using ONTAP 9.5. You verified that the iSCSI license is configured on your cluster and that the iSCSI protocol is enabled.
Referring to the exhibit, what is needed to allow hosts to log into the iSCSI target?

• A.Create new LIFs with the iSCSI data protocol.
• B.Add iSCSI to the data protocol of the existing LIFs.
• C.Create new igroups with the host IQNs.
• D.Map LUNs to the igroups.

Comment: *

Name: *

Email: *

Verification: *

Your company has begun to require additional restrictions on systems in the cloud. To comply with these new restrictions, you must have all incoming connections authorized to your Cloud Volumes ONTAP instance in Amazon Web Services (AWS).
Which two features enable you to satisfy your company's requirements for Red Hat Enterprise Linux 7 iSCSI hosts? (Choose two.)

• A.single initiator zoning
• B.iSCSI endpoint isolation
• C.routing failover groups
• D.Challenge-Handshake Authentication Protocol (CHAP)

Comment: *

Name: *

Email: *

Verification: *

Exhibit.

You are adding a boot LUN for a new server. The server uses FCP attached through a CNA.
The ONTAP cluster is also attached to the same fabric by way of UTA2. You configure the zoning for the fabric as shown in the exhibit. You discover that the server cannot see its boot LUN.
What is the problem with your zoning configuration?

• A.The zone used a wrong zone ID.
• B.The zone set must have the same name as the zone.
• C.The zone was not activated.
• D.The WWPN for the NetApp LIF is incorrect.

Comment: *

Name: *

Email: *

Verification: *