A user's home directory, mounted using NFS, has been encrypted by a ransomware attack. Theuser asks you to retrieve the data.
In this scenario, which process would allow you to accomplish this task?

• A.Take a new Snapshot copy of the volume.
• B.Apply the MirrorAllSnapshots policy to the volume.
• C.Restore the data from a Snapshot copy.
• D.Apply the XDPDefault policy to the volume.

Comment: *

Name: *

Email: *

Verification: *

You decide to enable SnapMirror network compression on your NetApp clustered Data ONTAP environment. Which two statementsare correct about enabling this feature?
(Choose two.)

• A.The data transfer between the clusters must use the NDMP protocol.
• B.You may only enable SnapMirror network compression on one HApair in a cluster, and traffic 1-1 is limited to routing through those nodes.
• C.The compression engine creates multiple transfer threads corresponding to the number of CPUs on the source storage system.
• D.The data is compressed only while it traverses the network.

Comment: *

Name: *

Email: *

Verification: *

Click the Exhibit button.

You want to restore a file from the engineering volume that is shown in the exhibit. When you click Restore in OnCommand Unified Manager, there are no files available to restore.
Referring to the exhibit, what caused this problem?

• A.The engineering volume is currently online.
• B.Workflow Automation is not configured to restore files from Snapshot copies.
• C.No Snapshot copies exist for the engineering volume.
• D.The engineering volume is unprotected.

Comment: *

Name: *

Email: *

Verification: *

When you configure a SnapLock feature, where should the ComplianceClock be initialized?

• A.on each SVM that hosts a SnapLock volume
• B.on all the nodes of the cluster
• C.on each aggregate that hosts a SnapLock volume
• D.on each node that hosts a SnapLock aggregate

Comment: *

Name: *

Email: *

Verification: *

You want to perform a health check of the MetroCluster synchronization status.
Which two actions should you perform? (Choose two.)

• A.In On Command System Manager, go to the Cluster in the Metro Cluster section.
• B.On the cluster shell, use the metrocluster replication show command.
• C.Run the MetroCluster Health Check tool from your administration host.
• D.In On Command Unified Manager, go to the Cluster in the MetroCluster tab.
• E.On the cluster shell, use the metrocluster check run command.

Comment: *

Name: *

Email: *

Verification: *