At what point does the Route Target become associated with a route?

• A.When the route is exported into the MP-BGP table from the VRF
• B.When the route from the PE is populated into the VRF at the CE
• C.When the route is propagated from the PE to the CE
• D.When the route from the CE is populated into the VRF at the PE
• E.When the route is first received at the P from the PE

Comment: *

Name: *

Email: *

Verification: *

In RSTP, how is the root bridge selected?

• A.The switch with the highest bridge-id is selected as root.
• B.The switch with the highest MAC address is selected as root
• C.The switch with the lowest MAC address is selected as root.
• D.The switch with the lowest bridge-id is selected as root.

Comment: *

Name: *

Email: *

Verification: *

Click the exhibit.

Assuming the network is IPv6 only, which of the following configurations on the Alcatel-Lucent
7750 SR router A can establish an IPv6 BGP session to router B?

• A.Option A
• B.Option D
• C.Option C
• D.Option B

Comment: *

Name: *

Email: *

Verification: *

Which command is used to generate the output from an Alcatel-Lucent 7750 SR shown below?

• A.Show service 3 detail
• B.Show service 3 base
• C.Show service 3
• D.Show service id 3
• E.Show service id 3 base
• F.Show service id 3 detail

Comment: *

Name: *

Email: *

Verification: *

How do user VPLSs become associated with a management VPLS for redundant spoke-sdp connections?

• A.The association must be defined in the user VPLS service.
• B.The association is done when the user VPLS is associated with the same sdp-id in the management VPLS
• C.The association is based on service IDs.
• D.The association is based on customer IDs.

Comment: *

Name: *

Email: *

Verification: *