You are configuring a VPLS spoke termination to a VPRN on an Alcatel-Lucent 7750 SR. If LDP is used for all transport tunnels, what type of sessions are established by the VPRN PE router that is configured with the spoke termination?

• A.LDP sessions with the other VPRN PE routers and the VPLS PE router
• B.T-LDP sessions with the other VPRN PE routers and the VPLS PE router
• C.T-LDP and LDP sessions with the other VPRN PE routers and LDP sessions with the VPLS PE router
• D.LDP sessions with the other VPRN PE routers, and both T-LDP and LDP sessions with the VPLS PE router
• E.T-LDP and LDP sessions with the other VPRN PE routers and the VPLS PE router

Comment: *

Name: *

Email: *

Verification: *

Router R4 is an Alcatel-Lucent 7750 SR configured for the extranet VPRN network. Which CLI command is executed on router R4 to produce the displayed output?

• A."show router route-table"
• B.There is no CLI command that can produce this output on router R4
• C."show router 10 route-table"
• D."show router 20 route-table"

Comment: *

Name: *

Email: *

Verification: *

Which of the following statements regarding the Originator_ID attribute is TRUE?

• A.The Originator_IDis set to the ClusterJD of the advertising router reflector.
• B.The BGP router that originates an update sets the Originator_ID .
• C.A BGP router ignores an update that contains its own BGP router ID as Originator_ID .
• D.Both confederation and route reflector topologies use the Originator_ID .

Comment: *

Name: *

Email: *

Verification: *

For the data packets in a VPRN, how is the inner label in an MPLS packet signaled?

• A.Signaled via T-LDP and used to identify the customer VPRN
• B.Signaled via RSVP and LDP and used to identify the customer VPRN
• C.Signaled via MP-BGP and used to identify the customer VPRN
• D.Signaled via MP-BGP and used to identify the egress PE
• E.Signaled via RSVP and LDP and used to identify the egress PE.

Comment: *

Name: *

Email: *

Verification: *

The policies shown below from the configuration of an Alcatel-Lucent 7750 SR have been created to implement an Extranet VPRN between the main sites of two separate VPRNs. How should these policies be applied?

• A.ample Policy should be applied as an export policy on the PE connected to the main site of Customer 1
• B.ample Policy should be applied as an export policy on all PEs connected to sites of Customer 1
• C.ample Policy 3 should be applied as an export policy on both PEs connected to the main site of Customer 1 and the main site of Customer 2
• D.ample Policy 3 should be applied as an export policy on the PE connected to the main site of Customer 2
• E.ample Policy should be applied as an export policy on both PEs connected to the main site of Customer 1 and the main site of Customer 2

Comment: *

Name: *

Email: *

Verification: *