Refer to the exhibit.

An administrator receive the warning massages shown in the exhibit while validating cluster conversion from EXSi to AHV.
What should the administrator do to address this warning in v Center Server?

• A.Keep active adapters od different speeds as active standby
• B.Remove the standby adapters under Teaming and Failover.
• C.Keep homogeneous adapter as active and standby
• D.Remove adapters that are active but not homogeneous.

Comment: *

Name: *

Email: *

Verification: *

An administrator wants to utilize Network Visualization to monitor the physical and logical network on the Nutanix cluster. The first-hop switch has LLDP enabled. The network switch information is still not being displayed.
What is causing this problem?

• A.The ISL between switches is not configured.
• B.SNMP is not configured properly.
• C.br0 and br1 are not defined.
• D.The cluster is using RDMA-enabled NICs.

Comment: *

Name: *

Email: *

Verification: *

For several days, an administrator notices the following alerts:
* CVM NIC Speed Low Warning Alerts
* Warning Alerts of CVM NIC not performing at optimal speed
* CVM is disconnected from the network Critical Alert
* Network Visualization page shows excessive dropped packets on CVM/Host Which steps should be taken to determine which problem should be addressed first?

• A.* Access the Hardware Page to verify resources are available
  * Analyze ail CVM Speed Alerts in the Alerts/Events page
  * Analyze output for the network and interface properties and connectivity issues
• B.* Verify Host/CVM connectivity on the Network Visualization page
  * Use to verify the bridge and bond configuration
  * Review alerts/events page for the CVM disconnected error
• C.* Review Alerts page for NIC speed alerts and alert timing
  * Analyze the genesis.out log file for process failures
  * Assess the NIC properties in the Network Visualization > Host Properties page
• D.* Restart networking services on the CVM
  * Determine the current configuration of the affected CVM via output
  * Access the Alerts/Events page for the CVM network connection failures

Comment: *

Name: *

Email: *

Verification: *

An administrator has a 32-node hybrid cluster with CPU, RAM and storage utilization of 80%. A database VM is configured with VM Flash.
What is causing this IO latency?

• A.Curator scans causes by ILM constantly moving data.
• B.Controller VM is experiencing high CPU ready time.
• C.Database VM is experiencing high CPU ready time.
• D.VM Flash Mode reduces SSD tier capacity for VMs.

Comment: *

Name: *

Email: *

Verification: *

An administrator is performing a set of routine checks and notes that Prism Central is running with 4 vCPUs and 21 GB RAM. The organizations environment is based on two Nutanix clusters with 170 VMs plus a Legacy vSphere infrastructure. No manual changes have been done on Prism Central VM.
Which configuration justifies the current Prism Central configuration?

• A.Nutanix Leap and Nutanix Flow have been enabled on Prism Central
• B.Prism Central was installed for Large Deployment environments.
• C.Nutanix Move is running on Prism Central to import VMs from the Legacy Cluster.
• D.Prism Central is running on the legacy duster and requires more RAM.

Comment: *

Name: *

Email: *

Verification: *