A network Administrator needs to view the default action for a specific spyware signature. The administrator follows the tabs and menus through Objects> Security Profiles> Anti-Spyware and select default profile.
What should be done next?

• A.View the default actions displayed in the Action column.
• B.Click the Exceptions tab and then click show all signatures.
• C.Click the simple-critical rule and then click the Action drop-down list.
• D.Click the Rules tab and then look for rules with "default" in the Action column.

Comment: *

Name: *

Email: *

Verification: *

View the GlobalProtect configuration screen capture.

What is the purpose of this configuration?

• A.It configures the tunnel address of all internal clients to an IP address range starting at 192.168.10.1.
• B.It forces an internal client to connect to an internal gateway at IP address 192.168.10.1.
• C.It enables a client to perform a reverse DNS lookup on 192.168.10.1 to detect that it is an internal client.
• D.It forces the firewall to perform a dynamic DNS update, which adds the internal gateway's hostname and IP address to the DNS server.

Comment: *

Name: *

Email: *

Verification: *

Based on the image, what caused the commit warning?

• A.SSL Forward Proxy requires a public certificate to be imported into the firewall.
• B.The FWDtrust certificate has not been flagged as Trusted Root CA.
• C.The FWDtrust certificate does not have a certificate chain.
• D.The CA certificate for FWDtrust has not been imported into the firewall.

Comment: *

Name: *

Email: *

Verification: *

An engineer is configuring Packet Buffer Protection on ingress zones to protect from single-session DoS attacks Which sessions does Packet Buffer Protection apply to?

• A.It applies to existing sessions and is global
• B.It applies to existing sessions and is not global
• C.It applies to new sessions and is global
• D.It applies to new sessions and is not global

Comment: *

Name: *

Email: *

Verification: *

How would an administrator monitor/capture traffic on the management interface of the Palo Alto Networks NGFW?

• A.Use the debug dataplane packet-diag set capture stage firewall file command.
• B.Use the topdump command.
• C.Enable all four stages of traffic capture (TX, RX, DROP, Firewall).
• D.Use the debug dataplane packet-diag set capture stage management file command.

Comment: *

Name: *

Email: *

Verification: *