The administrator has enabled BGP on a virtual router on the Palo Alto Networks NGFW, but new routes do not seem to be populating the virtual router.
Which two options would help the administrator troubleshoot this issue? (Choose two.)

• A.Perform a traffic pcap on the NGFW to see any BGP problems.
• B.View the ACC tab to isolate routing issues.
• C.View the System logs and look for the error messages about BGP.
• D.View the Runtime Stats and look for problems with BGP configuration.

Comment: *

Name: *

Email: *

Verification: *

Several offices are connected with VPNs using static IPv4 routes.
An administrator has been tasked with implementing OSPF to replace static routing.
Which step is required to accomplish this goal?

• A.Enable OSPFv3 on each tunnel interface and use Area ID 0.0.0.0
• B.Create new VPN zones at each site to terminate each VPN connection
• C.Assign OSPF Area ID 0.0.0.0 to all Ethernet and tunnel interfaces
• D.Assign an IP address on each tunnel interface at each site

Comment: *

Name: *

Email: *

Verification: *

What steps should a user take to increase the NAT oversubscription rate from the default platform setting?

• A.Navigate to Device > Setup > TCP Settings > NAT Oversubscription Rate
• B.Navigate to Policies > NAT > Destination Address Translation > Dynamic IP (with session distribution)
• C.Navigate to Policies > NAT > Source Address Translation > Dynamic IP (with session distribution)
• D.Navigate to Device > Setup > Session Settings > NAT Oversubscription Rate

Comment: *

Name: *

Email: *

Verification: *

What are three reasons why an installed session can be identified with the "application incomplete" tag? (Choose three.)

• A.There was no application data after the TCP connection was established.
• B.The client sent a TCP segment with the PUSH flag set.
• C.The TCP connection was terminated without identifying any application data.
• D.There is not enough application data after the TCP connection was established.
• E.The TCP connection did not fully establish.

Comment: *

Name: *

Email: *

Verification: *

An administrator has 750 firewalls The administrator's central-management Panorama instance deploys dynamic updates to the firewalls The administrator notices that the dynamic updates from Panorama do not appear on some of the firewalls.
If Panorama pushes the configuration of a dynamic update schedule to managed firewalls, but the configuration does not appear what is the root cause?

• A.Panorama has no connection to Palo Alto Networks update servers
• B.Panorama does not have valid licenses to push the dynamic updates
• C.No service route is configured on the firewalls to Palo Alto Networks update servers
• D.Locally-defined dynamic update settings take precedence over the settings that Panorama pushed

Comment: *

Name: *

Email: *

Verification: *